« previous next »
Pages: [1] 2   Go Down

Author Topic: Devcon 14300 Plastic Welder  (Read 777 times)

0 Members and 34 Guests are viewing this topic.

Offline KilliansRedLeo

  • Nitro Hotsaw
  • *******
  • Posts: 2361
  • Karma: 80
  • Location: Rochester, NY
    • RoCHusqvarna

    • Total Badges: 29
    Badges: (View All)
    2000 post CR Staff One year Anniversary 1000 Posts Never Sleep Group
Re: Devcon 14300 Plastic Welder
« on: October 11, 2014, 04:12:47 am »
Well it has been on there 6 of the 16 hour full cure time, can't peel it off and it is not leaking so far. Will run it a little and see if it leaks, report back.
Logged
"When the people fear the government...you have tyranny....When the government fears the people....you have liberty"

Thomas Jefferson
1743-1826
Pages: [1] 2   Go Up
« previous next »
 

Related Topics

  Subject / Started by Replies Last post
0 Replies
462 Views 		Last post November 06, 2011, 07:52:07 pm
by Cut4fun
0 Replies
488 Views 		Last post January 14, 2013, 03:25:17 pm
by Cut4fun .
4 Replies
845 Views 		Last post July 01, 2013, 11:42:19 am
by SawTroll
6 Replies
859 Views 		Last post April 18, 2014, 09:50:53 am
by WoodChips
9 Replies
1350 Views 		Last post September 09, 2014, 08:03:33 am
by pete
3 Replies
340 Views 		Last post January 18, 2015, 01:33:45 pm
by 660magnum
1 Replies
350 Views 		Last post May 21, 2015, 01:22:00 pm
by 660magnum
6 Replies
548 Views 		Last post July 29, 2015, 01:51:18 pm
by Chris-PA
4 Replies
612 Views 		Last post February 10, 2016, 09:08:31 pm
by Al Smith
0 Replies
132 Views 		Last post August 29, 2023, 08:58:18 am
by Cut4fun .