Author Topic: Need a metal fabricator  (Read 1156 times)

0 Members and 21 Guests are viewing this topic.

Offline srcarr52

  • 6 cube
  • ****
  • Posts: 288
  • Karma: 94
  • Location: IA

  • Total Badges: 22
    Badges: (View All)
    Third year Anniversary Level 5 Second year Anniversary 100 Posts Topic Starter Search
Re: Need a metal fabricator
« Reply #10 on: December 10, 2014, 10:13:45 am »

We'll see what it's like when it gets here.  If I can weld it I will, if not I'll cut a new one out of 1020 cold roll. 

Have you had an opportunity to check out the lock that I sent to you?

Chuck


I got a chance to look at it last night.  It's cast, but tight grain cast.  The other side has been welded before and this side **** right where there was a grinding line from the previous fix.  A little high nickle weld filler and some careful blending of the welds should have this back up and running.

 

Related Topics

  Subject / Started by Replies Last post
3 Replies
1500 Views
Last post January 10, 2018, 07:47:10 am
by Cut4fun .
4 Replies
829 Views
Last post August 02, 2011, 03:27:25 pm
by Al Smith
1 Replies
985 Views
Last post May 09, 2012, 08:32:08 pm
by Al Smith
12 Replies
1085 Views
Last post December 28, 2012, 07:52:28 pm
by Al Smith
2 Replies
726 Views
Last post February 10, 2013, 08:09:53 pm
by Al Smith
10 Replies
895 Views
Last post January 10, 2014, 12:35:53 pm
by Cut4fun .
14 Replies
916 Views
Last post March 29, 2015, 01:51:20 pm
by Cut4fun .
15 Replies
2459 Views
Last post December 15, 2018, 09:05:17 am
by HUSKY KEV
5 Replies
1346 Views
Last post April 08, 2023, 08:46:11 am
by Cut4fun .
1 Replies
415 Views
Last post September 18, 2017, 08:38:44 pm
by 3000 FPS