« previous next »
Pages: 1 [2]   Go Down

Author Topic: Porting tools  (Read 1288 times)

0 Members and 0 Guests are viewing this topic.

Online 3000 FPS

  • Moderator
  • Nitro Hotsaw
  • *******
  • Posts: 4687
  • Karma: 319
  • Location: Carpenter, Wyoming
Re: Porting tools
« Reply #10 on: January 22, 2014, 12:03:37 pm »
Nice.
Logged
PP 505, 475, 445.

Offline Cut4fun .

  • Administrator
  • Nitro Hotsaw
  • *******
  • Posts: 23357
  • Karma: 659
  • OHIO REDNECK Saw Repair Getter Done
    • Redneck Chainsaw Repair
Re: Porting tools
« Reply #11 on: January 22, 2014, 04:17:08 pm »
What is that top one laying across?   I like that idea if it works. Looks like for only very tiny bits?



Logged

Online srcarr52

  • 6 cube
  • ****
  • Posts: 288
  • Karma: 94
  • Location: IA
Re: Porting tools
« Reply #12 on: January 27, 2014, 11:10:44 am »
Quote from: Cut4fun_ on January 22, 2014, 04:17:08 pm
What is that top one laying across?   I like that idea if it works. Looks like for only very tiny bits?



It's an early foredom quick change model.  I can't remember the exact number but it has no bearings in it and gets hot enough to burn you within 2 minutes of use. 
Logged
Pages: 1 [2]   Go Up
« previous next »
 

Related Topics

  Subject / Started by Replies Last post
6 Replies
1650 Views 		Last post June 01, 2016, 09:03:45 pm
by RobbinW
Poulan 295 Porting

Started by Dh1984 « 1 2 » Poulan

11 Replies
2202 Views 		Last post May 20, 2011, 08:55:11 am
by Dh1984
0 Replies
484 Views 		Last post May 04, 2011, 02:52:08 pm
by farmboy
3 Replies
615 Views 		Last post September 03, 2011, 12:36:51 pm
by Old Iron Logging
37 Replies
5723 Views 		Last post February 21, 2014, 03:18:14 am
by fordfairlane78
37 Replies
4403 Views 		Last post October 03, 2015, 03:16:04 pm
by 660magnum
11 Replies
1387 Views 		Last post February 08, 2014, 11:44:49 am
by KilliansRedLeo
10 Replies
541 Views 		Last post May 02, 2016, 10:46:34 pm
by mdavlee .
18 Replies
613 Views 		Last post November 23, 2016, 11:04:05 pm
by oldpro
0 Replies
176 Views 		Last post July 01, 2017, 07:41:39 pm
by flyingdg