Author Topic: Powerhead stand vise chainsaw or cylinder etc  (Read 3309 times)

0 Members and 1 Guest are viewing this topic.

Offline Eccentric

  • Moderator
  • Nitro Hotsaw
  • *******
  • Posts: 2110
  • Karma: 217
  • Magnesium and Iron.
  • Location: Northern California.
Re: Powerhead stand vise chainsaw or cylinder etc
« Reply #30 on: September 19, 2015, 01:27:34 am »
When I worked for Sears Service back in the early 1990's, there was an old tech who used a bicycle clamp stand contraption to hold weed wackers while he was working on them.  I used it a few times.  Pretty handy...
-Aaron

For older saws:
Tune the H side so that it 4-strokes (burbles) at WOT unloaded and just cleans up when under load.
When you lift cutting load, the saw should immediately revert to 4-stroking.  Fine tune the transition point for the wood you're cutting.

 

Related Topics

  Subject / Started by Replies Last post
Cant stand

Started by man of stihl « 1 2 ... 5 6 » Tool Shed

53 Replies
2200 Views
Last post June 18, 2019, 02:40:59 pm
by Cut4fun .
3 Replies
1214 Views
Last post March 01, 2012, 08:34:40 pm
by Old Iron Logging
6 Replies
874 Views
Last post March 12, 2012, 09:33:05 am
by 660magnum
11 Replies
623 Views
Last post June 12, 2012, 01:45:06 pm
by joe_indi
3 Replies
887 Views
Last post June 22, 2012, 10:47:14 pm
by farmboy
2 Replies
451 Views
Last post July 28, 2012, 04:22:14 pm
by Cut4fun
4 Replies
439 Views
Last post August 02, 2012, 04:06:14 pm
by splitpost
5 Replies
593 Views
Last post February 15, 2013, 01:18:19 pm
by niel logman
63 Replies
2074 Views
Last post July 14, 2014, 08:11:28 pm
by HolmenTree
8 Replies
248 Views
Last post July 22, 2015, 08:20:52 pm
by Nathaniel Vansickle