Author Topic: Left Coast Supplies  (Read 953 times)

0 Members and 0 Guests are viewing this topic.

Offline Eccentric

  • Moderator
  • Nitro Hotsaw
  • *******
  • Posts: 2111
  • Karma: 215
  • Magnesium and Iron.
  • Location: Northern California.
Re: Left Coast Supplies
« Reply #20 on: September 14, 2014, 03:30:01 am »
No worries.  I'm a bit slow sometimes.  I hear you on the 'tight' part.  Left Coast had some bars that I wanted for CHEAP...........but I was holding off until some more $ comes in.  Just saw that the bars I was going to grab have recently sold out........
-Aaron

For older saws:
Tune the H side so that it 4-strokes (burbles) at WOT unloaded and just cleans up when under load.
When you lift cutting load, the saw should immediately revert to 4-stroking.  Fine tune the transition point for the wood you're cutting.

 

Related Topics

  Subject / Started by Replies Last post
1 Replies
291 Views
Last post September 06, 2012, 02:19:05 pm
by Cut4fun
6 Replies
263 Views
Last post October 04, 2012, 01:26:19 pm
by Cut4fun
9 Replies
586 Views
Last post May 03, 2013, 01:44:44 pm
by HMLT360Pro
15 Replies
755 Views
Last post December 07, 2013, 03:39:46 pm
by Arrow13
25 Replies
1076 Views
Last post November 16, 2018, 11:46:20 am
by Cut4fun .
4 Replies
258 Views
Last post November 16, 2018, 11:50:33 am
by Cut4fun .
3 Replies
62 Views
Last post January 21, 2015, 11:01:22 pm
by Craigwell
7 Replies
297 Views
Last post September 11, 2015, 03:44:31 pm
by Cut4fun .
10 Replies
427 Views
Last post December 17, 2016, 05:22:18 am
by Eccentric