Author Topic: Poulan Poulan Pro bars - OEM & Oregon  (Read 819 times)

0 Members and 0 Guests are viewing this topic.

Offline Eccentric

  • Moderator
  • Nitro Hotsaw
  • *******
  • Posts: 2106
  • Karma: 215
  • Magnesium and Iron.
  • Location: Northern California.
Re: Poulan Poulan Pro bars - OEM & Oregon
« Reply #20 on: November 02, 2015, 03:28:15 pm »
I think I know what saw that bar is going on... 8)

That PP380 you went through for him. I bet.  ;)

That's what I'm thinking.  The 20" laminate bar that came to me with it when the saw was shipped was completely trashed.  Didn't even bother sending it on with the saw....
-Aaron

For older saws:
Tune the H side so that it 4-strokes (burbles) at WOT unloaded and just cleans up when under load.
When you lift cutting load, the saw should immediately revert to 4-stroking.  Fine tune the transition point for the wood you're cutting.

 

Related Topics

  Subject / Started by Replies Last post
Poulan 475

Started by Cut4fun « 1 2 ... 34 35 » Poulan

348 Replies
8590 Views
Last post October 19, 2018, 07:03:10 pm
by Cut4fun .
Poulan 415

Started by Cut4fun « 1 2 ... 8 9 » Poulan

82 Replies
2857 Views
Last post October 13, 2018, 10:03:37 pm
by Cut4fun .
Poulan 220

Started by Cut4fun . « 1 2 » Poulan

17 Replies
750 Views
Last post June 17, 2017, 12:25:32 pm
by Cut4fun .
Poulan 365

Started by Cut4fun « 1 2 ... 16 17 » Poulan

169 Replies
4724 Views
Last post January 31, 2018, 07:59:31 pm
by stubnail67
221 Replies
5399 Views
Last post June 21, 2018, 08:30:48 am
by Cut4fun .
4 Replies
427 Views
Last post November 23, 2012, 12:28:15 am
by Andyshine77
Poulan Bars OEM

Started by Cut4fun . « 1 2 » Poulan

19 Replies
460 Views
Last post February 11, 2018, 01:13:52 pm
by Cut4fun .
0 Replies
337 Views
Last post October 12, 2015, 10:41:19 am
by chainsawlady
4 Replies
120 Views
Last post November 15, 2015, 10:19:28 am
by SDB777
2 Replies
150 Views
Last post May 21, 2017, 08:59:45 pm
by Cut4fun .