Author Topic: Saw Chain Source  (Read 974 times)

0 Members and 0 Guests are viewing this topic.

Offline Eccentric

  • Moderator
  • Nitro Hotsaw
  • *******
  • Posts: 2110
  • Karma: 217
  • Magnesium and Iron.
  • Location: Northern California.
Re: Saw Chain Source
« Reply #30 on: February 16, 2015, 03:20:12 pm »
91 vxl yes.  the only thing i carry is .404 .080 for harvester bars but i need to order a roll of .404 skip. just havent found a deal on it yet. .404 is gold plated to oregon and Carlton doesnt have skip.

.404 Skip chisel and semi chisel is what I use for the most part.  Oregon 27AX and 68JGX IIRC.  Deals can be had on it by shopping around, but most of the local shops treat it like it's gold (if they even carry it).  Not much call for .404 anymore....
-Aaron

For older saws:
Tune the H side so that it 4-strokes (burbles) at WOT unloaded and just cleans up when under load.
When you lift cutting load, the saw should immediately revert to 4-stroking.  Fine tune the transition point for the wood you're cutting.

 

Related Topics

  Subject / Started by Replies Last post
5 Replies
549 Views
Last post January 31, 2012, 10:10:59 pm
by Al Smith
3 Replies
438 Views
Last post December 11, 2018, 04:09:16 pm
by fisaw
12 Replies
563 Views
Last post October 05, 2013, 09:25:13 am
by leec
26 Replies
821 Views
Last post February 03, 2014, 08:30:34 am
by SawTroll
2 Replies
185 Views
Last post December 19, 2013, 11:47:37 pm
by RoyM
1 Replies
90 Views
Last post December 24, 2013, 11:36:57 pm
by Cut4fun .
8 Replies
258 Views
Last post January 22, 2014, 11:23:10 pm
by jockeydeuce
8 Replies
147 Views
Last post April 27, 2014, 01:11:55 pm
by KilliansRedLeo
7 Replies
151 Views
Last post December 15, 2014, 01:28:20 pm
by 660magnum
26 Replies
1611 Views
Last post May 16, 2016, 09:03:07 pm
by Cut4fun .