« previous next »
Pages: [1]   Go Down

Author Topic: 111 jonsered intake and carb  (Read 178 times)

0 Members and 0 Guests are viewing this topic.

Offline Snoopy

  • 5 cube
  • ***
  • Posts: 128
  • Karma: 22
111 jonsered intake and carb
« on: November 18, 2013, 06:10:14 am »
Needing to buy 111 jonsered intake and carb. If you have on pm me. Thanks!!!!!!
Logged

Share on Facebook Share on Twitter

Offline jacob j.

  • 4 cube
  • **
  • Posts: 50
  • Karma: 16
Re: 111 jonsered intake and carb
« Reply #1 on: November 19, 2013, 02:47:39 pm »
Sawagain has two of the carbs, but I'm not seeing the intake manifold there. It might be worth calling Scott at Chainsawr as well.
Logged

Offline Cut4fun .

  • Administrator
  • Nitro Hotsaw
  • *******
  • Posts: 23417
  • Karma: 662
  • OHIO REDNECK Saw Repair Getter Done
    • Redneck Chainsaw Repair
Re: 111 jonsered intake and carb
« Reply #2 on: November 19, 2013, 05:19:57 pm »
Logged

Offline Snoopy

  • 5 cube
  • ***
  • Posts: 128
  • Karma: 22
Re: 111 jonsered intake and carb
« Reply #3 on: November 19, 2013, 07:41:10 pm »
Thanks for the leads ;D
Logged

Offline jacob j.

  • 4 cube
  • **
  • Posts: 50
  • Karma: 16
Re: 111 jonsered intake and carb
« Reply #4 on: November 19, 2013, 08:08:11 pm »
Saw Again is a good place to buy stuff but you have to be careful because they don't always know a whole lot about the parts they're selling. I bought a MS-460 crank from them once and it turned out to have a blown rod bearing. They gave me a refund immediately without question but they didn't know (or couldn't tell) that the crank was blown.
Logged
Pages: [1]   Go Up
« previous next »
 

Related Topics

  Subject / Started by Replies Last post
10 Replies
1540 Views 		Last post November 21, 2015, 08:36:08 am
by Cut4fun .
3 Replies
222 Views 		Last post January 18, 2014, 12:51:59 pm
by jacob j.
7 Replies
901 Views 		Last post February 13, 2014, 03:50:29 pm
by Spike60
2 Replies
145 Views 		Last post October 05, 2014, 03:44:30 pm
by farmboy
7 Replies
527 Views 		Last post December 18, 2014, 05:18:24 pm
by Nathaniel Vansickle
18 Replies
619 Views 		Last post November 23, 2016, 11:04:05 pm
by oldpro
1 Replies
113 Views 		Last post January 27, 2016, 11:34:07 am
by Skippysphins
64 Replies
1606 Views 		Last post June 17, 2016, 04:50:09 pm
by 1manband
8 Replies
1390 Views 		Last post November 14, 2016, 08:57:22 pm
by farmboy
6 Replies
471 Views 		Last post January 23, 2020, 08:52:42 pm
by ENTS