Author Topic: Welding Chainsaw Parts  (Read 5667 times)

0 Members and 0 Guests are viewing this topic.

Offline 3000 FPS

  • Moderator
  • Nitro Hotsaw
  • *******
  • Posts: 4470
  • Karma: 274
  • Location: Carpenter, Wyoming
Re: Welding Chainsaw Parts
« Reply #40 on: November 18, 2013, 08:53:49 pm »
I do not remember if I ever showed this weld job that I did on a Husqvarna crankshaft that was broken on the end where the c-clip goes. 





When the welding was completed I duct taped the piston to the counter balance of the crankshaft and then turned it on my lathe to get the groove for the c-clip back to the correct width. 
PP 505, 475, 445.

 

Related Topics

  Subject / Started by Replies Last post
3 Replies
692 Views
Last post June 07, 2012, 02:47:11 pm
by Dh1984
2 Replies
423 Views
Last post February 08, 2013, 10:51:18 pm
by mattinky
0 Replies
149 Views
Last post December 02, 2013, 10:34:35 am
by Forester Parts
5 Replies
1110 Views
Last post February 08, 2018, 08:28:16 pm
by Al Smith
3 Replies
262 Views
Last post November 05, 2015, 12:02:37 pm
by Cut4fun .
8 Replies
317 Views
Last post April 29, 2016, 11:47:09 am
by chy_farm
0 Replies
209 Views
Last post December 05, 2015, 10:17:42 am
by Cut4fun .
1 Replies
184 Views
Last post April 06, 2016, 04:17:50 pm
by aclarke
4 Replies
611 Views
Last post April 04, 2017, 08:28:52 pm
by Cut4fun .
3 Replies
478 Views
Last post May 06, 2020, 09:13:40 am
by Al Smith