« previous next »
Pages: [1]   Go Down

Author Topic: Anybody Hone Their Chains?  (Read 741 times)

0 Members and 9 Guests are viewing this topic.

Offline Philbert

  • Gas Hotsaw
  • ******
  • Posts: 563
  • Karma: 76

    • Total Badges: 23
    Badges: (View All)
    Seventh year Anniversary Sixth year Anniversary Level 5 Fifth year Anniversary 500 Posts Fourth year Anniversary
Re: Anybody Hone Their Chains?
« on: November 21, 2013, 04:23:10 pm »
So is 'smoother' better?  Or is a 'serrated' edge better?

I know that this falls into the 'doesn't-make-a-difference-for-the-average-user' category.  But what if, after filing or grinding, one went back with 400 or 600 grit silicon carbide paper wrapped around an appropriately sized dowel rod and polished the edge?  Aesthetics only ?

Philbert
Logged
Pages: [1]   Go Up
« previous next »
 

Related Topics

  Subject / Started by Replies Last post
12 Replies
975 Views 		Last post July 16, 2011, 04:25:56 pm
by Cut4fun
3 Replies
712 Views 		Last post February 02, 2012, 08:31:26 pm
by North West Farmer
8 Replies
688 Views 		Last post January 03, 2013, 06:42:14 pm
by Al Smith
6 Replies
574 Views 		Last post April 02, 2013, 03:07:32 pm
by Cut4fun .
0 Replies
199 Views 		Last post July 18, 2013, 02:37:47 pm
by Cut4fun .
1 Replies
362 Views 		Last post February 15, 2014, 07:27:10 pm
by jmester
15 Replies
953 Views 		Last post September 24, 2015, 03:14:48 pm
by mdavlee .
3 Replies
391 Views 		Last post November 11, 2015, 03:01:20 pm
by 660magnum
0 Replies
430 Views 		Last post March 17, 2016, 12:54:13 pm
by Cut4fun .
25 Replies
3055 Views 		Last post May 02, 2021, 09:32:40 am
by Cut4fun .