Author Topic: Fixable? Dealer says I'm screwed  (Read 1362 times)

0 Members and 25 Guests are viewing this topic.

Offline Philbert

  • Gas Hotsaw
  • ******
  • Posts: 563
  • Karma: 76

  • Total Badges: 23
    Badges: (View All)
    Seventh year Anniversary Sixth year Anniversary Level 5 Fifth year Anniversary 500 Posts Fourth year Anniversary
Nose Sprocket Repair - With Illustrations - 5
« Reply #10 on: May 01, 2014, 12:30:23 am »
5. Reassembly is the reverse. Slide the card all the way in to keep the little bearings from dropping through the rivet holes. It may help to pry apart the bar tip with a small screwdriver.

Once the sprocket is close, a little manipulation with a scratch awl helps align the other holes. Small nails can be used to hold things in place while setting the first rivets.

* For a STIHL bar with the side shims, I would either try to tie these in place with a very thin thread, or clean the shims and center disc with acetone and try a drop of SuperGlue to hold them in place.

 

Related Topics

  Subject / Started by Replies Last post
4 Replies
1320 Views
Last post May 08, 2013, 08:51:22 pm
by Old Iron Logging
29 Replies
2343 Views
Last post February 02, 2016, 01:39:22 pm
by mowertech
24 Replies
981 Views
Last post September 19, 2014, 10:07:22 pm
by newowner?
11 Replies
887 Views
Last post September 11, 2014, 03:39:37 am
by pigpen60
6 Replies
1093 Views
Last post August 30, 2015, 10:50:09 pm
by RoyM
6 Replies
652 Views
Last post September 02, 2015, 02:23:36 pm
by Cut4fun .
0 Replies
611 Views
Last post February 04, 2017, 10:46:00 am
by mowertech
4 Replies
269 Views
Last post March 07, 2023, 10:04:49 am
by Cut4fun .