« previous next »
Pages: 1 2 3 [4]   Go Down

Author Topic: Dolmar 112  (Read 3200 times)

0 Members and 16 Guests are viewing this topic.

Offline OldJack

  • 3 cube
  • *
  • Posts: 11
  • Karma: 2
  • Location: Saskatchewan

    • Total Badges: 13
    Badges: (View All)
    Level 3 10 Posts Fourth year Anniversary Third year Anniversary Karma Second year Anniversary
Re: Dolmar 112
« Reply #30 on: April 16, 2015, 02:56:58 am »
A point to consider, if you'll pardon the pun. I'm rusty on my points and condenser theory, but the points should open at the time of minimum current flow across them to prevent arcing and burning. Running with the wrong point gap isn't good for the points. The condenser controls the current flow across the points and a bad condenser will eat points.
Logged

Offline 3000 FPS

  • Moderator
  • Nitro Hotsaw
  • *******
  • Posts: 4706
  • Karma: 320
  • Location: Carpenter, Wyoming

    • Total Badges: 43
    Badges: (View All)
    Tenth year Anniversary Nineth year Anniversary Level 7 Eighth year Anniversary Seventh year Anniversary Sixth year Anniversary
Re: Dolmar 112
« Reply #31 on: April 16, 2015, 10:41:34 am »
I believe the condenser will discharge the voltage to ground instead of arching across the contacts of the points.   
That is the nature of capacitance.
Logged
PP 505, 475, 445.
Pages: 1 2 3 [4]   Go Up
« previous next »
 

Related Topics

  Subject / Started by Replies Last post
4 Replies
1123 Views 		Last post March 24, 2012, 11:18:52 am
by farmboy
9 Replies
679 Views 		Last post December 19, 2013, 08:36:56 pm
by fastleo151
13 Replies
1386 Views 		Last post January 11, 2014, 06:09:41 pm
by Bitburger
73 Replies
2823 Views 		Last post July 03, 2014, 12:15:14 pm
by Cut4fun .
Dolmar parts

Started by aclarke « 1 2 » Dolmar Makita

11 Replies
1517 Views 		Last post April 23, 2014, 11:50:04 am
by KilliansRedLeo
8 Replies
897 Views 		Last post August 26, 2014, 12:14:10 am
by stihls066
8 Replies
1499 Views 		Last post May 24, 2014, 12:12:54 am
by dutchsawdoctor
0 Replies
227 Views 		Last post April 12, 2014, 12:28:35 am
by stihls066
3 Replies
598 Views 		Last post April 21, 2014, 09:22:19 pm
by 3000 FPS
3 Replies
291 Views 		Last post April 22, 2023, 10:56:40 am
by Cut4fun .