Author Topic: K095 bar mount  (Read 1460 times)

0 Members and 0 Guests are viewing this topic.

Offline Cut4fun

  • Administrator
  • Nitro Hotsaw
  • *******
  • Posts: 4305
  • Karma: 188
  • OHIO REDNECK
Re: K095 bar mount
« on: May 24, 2011, 10:46:37 am »
I had a 24" small mount for my DN 357. I never did put it to use on the 357 and sent it to jred that says he runs the 24" on the 262. I wouldnt have had any problems with putting it on the 362xp.  I would prefer the torque of the 365 special top end on that mount.  Then again could put the 70.7cc, 74.66cc or BB 76cc on that mount for a sleeper  ;).
REDNECK Saw Repair

 

Related Topics

  Subject / Started by Replies Last post
0 Replies
59 Views
Last post September 21, 2013, 12:54:45 pm
by KilliansRedLeo
1 Replies
172 Views
Last post November 05, 2013, 12:38:23 am
by Eccentric
10 Replies
238 Views
Last post December 31, 2013, 06:13:12 pm
by 3000 FPS
4 Replies
170 Views
Last post April 03, 2015, 09:25:53 am
by wild262
8 Replies
204 Views
Last post June 17, 2015, 01:20:14 pm
by RoyM
15 Replies
694 Views
Last post September 09, 2015, 10:06:43 pm
by Eccentric
13 Replies
865 Views
Last post October 23, 2019, 10:56:27 am
by Cut4fun .
3 Replies
198 Views
Last post November 18, 2017, 10:37:14 am
by ray benson
0 Replies
130 Views
Last post July 19, 2018, 01:40:56 pm
by Hoggwood
1 Replies
61 Views
Last post July 08, 2019, 11:14:45 am
by Cut4fun .