« previous next »
Pages: [1]   Go Down

Author Topic: 306 top handle  (Read 1009 times)

0 Members and 48 Guests are viewing this topic.

Offline

  • 6 cube
  • ****
  • Posts: 264
  • Karma: 14
  • Location: Huntsville, Ontario

    • Total Badges: 23
    Badges: (View All)
    Sixth year Anniversary Fifth year Anniversary Level 5 Fourth year Anniversary Third year Anniversary 100 Posts
306 top handle
« on: July 12, 2017, 02:52:49 pm »
This is the one with the new piston.  Starts easily revs up but dies in the cut after 2-3 seconds.  Then starts up just fine.  Can't seem to get the H & L right.
Logged

Share on Bluesky Share on Facebook

Offline

  • 5 cube
  • ***
  • Posts: 119
  • Karma: 21

    • Total Badges: 21
    Badges: (View All)
    Level 5 Sixth year Anniversary Fifth year Anniversary 100 Posts Fourth year Anniversary Level 4
Re: 306 top handle
« Reply #1 on: July 14, 2017, 06:03:25 am »
 
 Check the metering valve height real close, If my saw I'd just bend it up a bit so it opens the needle a little more and give it a try.  Steve
Logged

Offline

  • 6 cube
  • ****
  • Posts: 264
  • Karma: 14
  • Location: Huntsville, Ontario

    • Total Badges: 23
    Badges: (View All)
    Sixth year Anniversary Fifth year Anniversary Level 5 Fourth year Anniversary Third year Anniversary 100 Posts
Re: 306 top handle
« Reply #2 on: July 19, 2017, 03:36:31 pm »
Thanks ,  I'll give it a try.
Logged
Pages: [1]   Go Up
« previous next »
 

Related Topics

  Subject / Started by Replies Last post
5 Replies
1688 Views 		Last post August 15, 2011, 01:48:52 pm
by Cut4fun
4 Replies
1677 Views 		Last post April 08, 2012, 06:50:42 am
by Old Iron Logging
4 Replies
1055 Views 		Last post November 03, 2013, 12:12:55 pm
by morningman
6 Replies
1929 Views 		Last post April 08, 2016, 08:41:29 pm
by Nathaniel Vansickle
0 Replies
1494 Views 		Last post October 23, 2016, 12:19:01 pm
by Cut4fun
3 Replies
3143 Views 		Last post November 30, 2020, 09:37:52 am
by Cut4fun .
10 Replies
6385 Views 		Last post May 13, 2025, 12:34:21 pm
by Cut4fun .
0 Replies
1388 Views 		Last post October 16, 2021, 07:52:56 pm
by burl
2 Replies
1209 Views 		Last post February 15, 2022, 10:09:28 am
by 3000 FPS
14 Replies
1939 Views 		Last post July 09, 2026, 08:23:48 am
by Cut4fun .