Author Topic: Echo 3900  (Read 6751 times)

0 Members and 54 Guests are viewing this topic.

Offline mountainlake

  • 5 cube
  • ***
  • Posts: 119
  • Karma: 21

  • Total Badges: 21
    Badges: (View All)
    Level 5 Sixth year Anniversary Fifth year Anniversary 100 Posts Fourth year Anniversary Level 4
Re: Echo 3900
« Reply #40 on: October 02, 2012, 06:07:15 am »

 My CS400 was cutting quite a bit faster than my CS4400 with a .325 setup. I switched over a CS4400 (43cc) from .325 7 tooth to 3/8 lo pro 6 tooth, gained a lot of cutting speed.   Same chain as the CS400 comes with, the spocket from the CS400 fit but was a bit too wide and had to be milled a little.  Now the CS4400 cuts a little faster than my CS400.   Steve

 

Related Topics

  Subject / Started by Replies Last post
Echo 280

Started by Cut4fun . « 1 2 » Echo

10 Replies
2044 Views
Last post May 21, 2013, 03:48:18 pm
by Cut4fun .
2 Replies
1009 Views
Last post February 06, 2012, 08:39:26 pm
by DB_43725
Echo 702

Started by Cut4fun . « 1 2 3 4 » Echo

32 Replies
4100 Views
Last post March 10, 2016, 03:44:56 pm
by Cut4fun .
Echo 452

Started by Cut4fun Echo

2 Replies
1206 Views
Last post April 23, 2012, 11:19:35 pm
by DB_43725
2 Replies
395 Views
Last post October 14, 2012, 05:28:29 pm
by Cut4fun .
1 Replies
695 Views
Last post October 27, 2012, 10:27:31 pm
by Al Smith
8 Replies
961 Views
Last post September 28, 2013, 03:47:02 pm
by Cut4fun .
6 Replies
716 Views
Last post August 03, 2018, 08:15:23 am
by Cut4fun
5 Replies
336 Views
Last post September 19, 2016, 01:03:18 pm
by Cut4fun .
9 Replies
3674 Views
Last post November 04, 2017, 08:43:38 pm
by Jaymo