Author Topic: Echo cylinder  (Read 824 times)

0 Members and 28 Guests are viewing this topic.

Offline sharkey

  • Piped Saw
  • *****
  • Posts: 368
  • Karma: 37

  • Total Badges: 26
    Badges: (View All)
    Tenth year Anniversary Nineth year Anniversary Eighth year Anniversary Seventh year Anniversary Sixth year Anniversary Level 5
Re: Echo cylinder
« Reply #10 on: November 27, 2014, 07:24:28 am »
I like my 520's especially with 18 inch bars and 325 lpx20 chain.  They are light and nimble. 

When you seal it up, make sure you get into the corners of the bearing pockets where they fit into the casting.  Use a little extra goo top and bottom (loctite 515).   

Offline Giles

  • 6 cube
  • ****
  • Posts: 157
  • Karma: 12
  • Location: Florence Alabama

  • Total Badges: 19
    Badges: (View All)
    Fifth year Anniversary Fourth year Anniversary Third year Anniversary Level 4 100 Posts Avatar
Re: Echo cylinder
« Reply #11 on: December 04, 2014, 01:14:03 pm »
I received the parts a few days ago---Fast---- and they looked really good. I installed a new set of rings and they gapped at seven thousands, after lightly cleaning cylinder with scotch-brite. Saw runs again---thanks to Cut4fun!

 

Related Topics

  Subject / Started by Replies Last post
13 Replies
2692 Views
Last post December 07, 2011, 05:32:23 pm
by brokenbudget
1 Replies
285 Views
Last post September 05, 2012, 05:23:21 pm
by Al Smith
044 Cylinder

Started by farmboy « 1 2 3 4 » Stihl

38 Replies
1810 Views
Last post June 02, 2013, 10:02:21 pm
by HolmenTree
54 Replies
3094 Views
Last post January 03, 2014, 02:14:59 pm
by Adirondackstihl
14 Replies
1157 Views
Last post February 25, 2014, 12:38:59 pm
by jacob j.
1 Replies
393 Views
Last post August 22, 2014, 08:33:48 pm
by 660magnum
7 Replies
778 Views
Last post January 18, 2016, 12:54:40 pm
by randy_das
4 Replies
362 Views
Last post November 06, 2016, 10:35:55 am
by SawTroll
7 Replies
652 Views
Last post August 25, 2017, 06:40:44 am
by jmester
0 Replies
326 Views
Last post December 23, 2022, 07:59:46 am
by Cut4fun .