« previous next »
Pages: [1]   Go Down

Author Topic: Nut/Bolt Torque  (Read 1250 times)

0 Members and 66 Guests are viewing this topic.

Offline Giles

  • 6 cube
  • ****
  • Posts: 157
  • Karma: 12
  • Location: Florence Alabama

    • Total Badges: 19
    Badges: (View All)
    Fifth year Anniversary Fourth year Anniversary Third year Anniversary Level 4 100 Posts Avatar
Re: Nut/Bolt Torque
« on: September 05, 2016, 04:36:35 pm »
Yeah that the way I have done it for over 50 years. Never had one come loose ---but why take the chance when I have a 3/8 calibrated Armstrong wrench.
I have also replace a lot of crankshafts that were twisted off from over tightening and replaced a few coils and other items when they came loose!
Logged
Pages: [1]   Go Up
« previous next »
 

Related Topics

  Subject / Started by Replies Last post
22 Replies
3666 Views 		Last post September 20, 2014, 06:12:53 pm
by aclarke
9 Replies
920 Views 		Last post December 03, 2013, 10:21:18 am
by Cut4fun .
31 Replies
2068 Views 		Last post November 17, 2013, 05:05:45 pm
by oldtimber
4 Replies
778 Views 		Last post June 26, 2015, 10:22:07 pm
by jmester
1 Replies
570 Views 		Last post January 25, 2016, 11:21:00 am
by srcarr52
1 Replies
461 Views 		Last post February 12, 2016, 09:13:00 am
by fuzz1500
4 Replies
825 Views 		Last post February 06, 2019, 01:46:24 pm
by HolmenTree
1 Replies
628 Views 		Last post May 19, 2019, 07:45:02 am
by Cut4fun .
1 Replies
645 Views 		Last post December 21, 2020, 10:41:19 am
by Cut4fun .
1 Replies
24 Views 		Last post April 04, 2024, 06:32:18 am
by Cut4fun .