I rebuilt a 330 couple years ago- New rings, new boot, plug, lines, carb kit, etc - ran great but now it won't start. Will pop with fuel in the carb but won't pull fuel from tank. Rebuilt carb again including pulling welch plug and insuring the progression ports aren't plugged.
Can't figure out why it won't pull fuel
I'm at a loss without totally tearing this thing down. Really could use the benefit of others' experience with this misogynistic POS or other saws with same problem.
Be advised that I was studiously careful when rebuilding this. It ran well right afterward but after sitting for couple years it won't start. Only ever had non ethanol in it.
I'm resigned to having to take it apart again but dread doing so. only thing I can figure is hole in impulse line. we'll see.