Author Topic: 272 cylinder on a 254?  (Read 339 times)

0 Members and 0 Guests are viewing this topic.

Offline KilliansRedLeo

  • Nitro Hotsaw
  • *******
  • Posts: 2361
  • Karma: 80
  • Location: Rochester, NY
    • RoCHusqvarna
Re: 272 cylinder on a 254?
« Reply #10 on: February 25, 2014, 07:27:54 am »
Quote
Or the cylinder is sitting lower relative to the crank?

I don't know the details.

Yes, I agree that is also a possibility. We would need to know the deck height from crank shaft center, as well as the actual length of the rod from crank pin center to piston pin center (I think? ???). In order to try to figure it out. None of these measurements can I find anywhere, I can't even find anything from HVA stating the deck height.
"When the people fear the government...you have tyranny....When the government fears the people....you have liberty"

Thomas Jefferson
1743-1826

 

Related Topics

  Subject / Started by Replies Last post
4 Replies
119 Views
Last post February 13, 2016, 11:05:35 am
by sharkey
2 Replies
278 Views
Last post November 07, 2016, 05:17:35 pm
by oldpro
4 Replies
130 Views
Last post November 06, 2016, 10:35:55 am
by SawTroll
3 Replies
336 Views
Last post November 21, 2016, 02:29:41 pm
by Cut4fun .
1 Replies
310 Views
Last post November 22, 2016, 05:54:51 pm
by Cut4fun .
7 Replies
223 Views
Last post August 25, 2017, 06:40:44 am
by jmester
10 Replies
399 Views
Last post August 22, 2018, 07:58:11 am
by pete
5 Replies
144 Views
Last post November 19, 2019, 11:03:09 am
by Cut4fun .
0 Replies
45 Views
Last post February 17, 2020, 07:27:15 am
by Cut4fun
4 Replies
183 Views
Last post February 29, 2020, 07:34:27 am
by Cut4fun .