« previous next »
Pages: 1 [2] 3 4 5 6   Go Down

Author Topic: Cylinder help again  (Read 3153 times)

0 Members and 26 Guests are viewing this topic.

Offline KilliansRedLeo

  • Nitro Hotsaw
  • *******
  • Posts: 2361
  • Karma: 80
  • Location: Rochester, NY
    • RoCHusqvarna

    • Total Badges: 29
    Badges: (View All)
    2000 post CR Staff One year Anniversary 1000 Posts Never Sleep Group
Re: Cylinder help again
« Reply #10 on: December 29, 2013, 02:23:08 pm »
I assume from the pictures that all you got was the cylinder, correct? Take your calipers and measure the diameter of the bore on #1 if it is a 266 it will be 50mm as Magnus stated.

Quote
Should be different diameter on them 50mm on 266, 48mm on 630.

What are the casting numbers of the cylinder on the saw now?

What makes you think your cylinder needs to be replaced?

If you have both the cylinder and piston, and it is 50mm your home free, otherwise you will have to pull your jug to be sure
Logged
"When the people fear the government...you have tyranny....When the government fears the people....you have liberty"

Thomas Jefferson
1743-1826
Pages: 1 [2] 3 4 5 6   Go Up
« previous next »
 

Related Topics

  Subject / Started by Replies Last post
4 Replies
451 Views 		Last post February 13, 2016, 11:05:35 am
by sharkey
2 Replies
561 Views 		Last post November 07, 2016, 05:17:35 pm
by oldpro
1 Replies
624 Views 		Last post November 22, 2016, 05:54:51 pm
by Cut4fun .
7 Replies
660 Views 		Last post August 25, 2017, 06:40:44 am
by jmester
10 Replies
918 Views 		Last post August 22, 2018, 07:58:11 am
by pete
5 Replies
467 Views 		Last post November 19, 2019, 11:03:09 am
by Cut4fun .
0 Replies
202 Views 		Last post February 17, 2020, 07:27:15 am
by Cut4fun
4 Replies
474 Views 		Last post February 29, 2020, 07:34:27 am
by Cut4fun .
0 Replies
328 Views 		Last post December 23, 2022, 07:59:46 am
by Cut4fun .
0 Replies
15 Views 		Last post April 15, 2024, 08:38:34 am
by Cut4fun .