Author Topic: Cylinder help again  (Read 3094 times)

0 Members and 26 Guests are viewing this topic.

Offline KilliansRedLeo

  • Nitro Hotsaw
  • *******
  • Posts: 2361
  • Karma: 80
  • Location: Rochester, NY
    • RoCHusqvarna

  • Total Badges: 29
    Badges: (View All)
    2000 post CR Staff One year Anniversary 1000 Posts Never Sleep Group
Re: Cylinder help again
« Reply #10 on: December 29, 2013, 09:14:12 pm »
The 266 had a 50mm bore, the Jonsered 630 is 48mm as is the Husqvarna 61. IIRC the Husqvarna 61 and the Jonsered 630 are basically the same saw.

Good luck with the cylinder replacement. IIRC the torque specs state 8-9NM for the jug, and use a NEW base gasket! As well as a good amount of 2-stroke oil in the bore, you do not want to start the saw with the cylinder dry!
"When the people fear the government...you have tyranny....When the government fears the people....you have liberty"

Thomas Jefferson
1743-1826

 

Related Topics

  Subject / Started by Replies Last post
4 Replies
442 Views
Last post February 13, 2016, 11:05:35 am
by sharkey
2 Replies
555 Views
Last post November 07, 2016, 05:17:35 pm
by oldpro
4 Replies
362 Views
Last post November 06, 2016, 10:35:55 am
by SawTroll
1 Replies
618 Views
Last post November 22, 2016, 05:54:51 pm
by Cut4fun .
7 Replies
652 Views
Last post August 25, 2017, 06:40:44 am
by jmester
10 Replies
896 Views
Last post August 22, 2018, 07:58:11 am
by pete
5 Replies
463 Views
Last post November 19, 2019, 11:03:09 am
by Cut4fun .
0 Replies
202 Views
Last post February 17, 2020, 07:27:15 am
by Cut4fun
4 Replies
467 Views
Last post February 29, 2020, 07:34:27 am
by Cut4fun .
0 Replies
326 Views
Last post December 23, 2022, 07:59:46 am
by Cut4fun .