« previous next »
Pages: 1 ... 6 7 8 9 10 [11] 12   Go Down

Author Topic: Husky 350 mod options  (Read 11979 times)

0 Members and 16 Guests are viewing this topic.

Offline

  • Nitro Hotsaw
  • *******
  • Posts: 2361
  • Karma: 80
  • Location: Rochester, NY
    • RoCHusqvarna

    • Total Badges: 29
    Badges: (View All)
    2000 post CR Staff One year Anniversary 1000 Posts Never Sleep Group
Re: Husky 350 mod options
« Reply #100 on: February 24, 2014, 11:46:15 am »
I have had the same problem with the screws. I either pop rivet them or, I have trying using a long tapered punch, drill a very small hole where the screw goes, then use the punch to form the thin metal into a funnel shape a little smaller than the screws I am using. IMHO the taper in the hole gives the screws more purchase. I have one together like that and so far it is holding, not a 350 but a 372 but should not make a difference.
Logged
"When the people fear the government...you have tyranny....When the government fears the people....you have liberty"

Thomas Jefferson
1743-1826
Pages: 1 ... 6 7 8 9 10 [11] 12   Go Up
« previous next »
 

Related Topics

  Subject / Started by Replies Last post
5 Replies
3265 Views 		Last post August 18, 2011, 10:01:40 am
by Cut4fun .
103 Replies
13134 Views 		Last post February 24, 2014, 05:49:35 am
by 350XP
6 Replies
2540 Views 		Last post March 17, 2012, 11:06:21 pm
by Al Smith
11 Replies
6723 Views 		Last post May 18, 2012, 10:03:11 pm
by Al Smith
8 Replies
3391 Views 		Last post September 15, 2012, 02:02:54 pm
by Cut4fun .
8 Replies
3093 Views 		Last post September 18, 2012, 03:51:15 pm
by Cut4fun .
6 Replies
1690 Views 		Last post January 11, 2014, 04:10:04 pm
by procarbine2k1
10 Replies
2555 Views 		Last post September 22, 2015, 09:59:55 pm
by ch74
15 Replies
5904 Views 		Last post March 10, 2016, 02:51:43 pm
by Cut4fun .
3 Replies
437 Views 		Last post November 03, 2025, 07:32:02 am
by Cut4fun .