Author Topic: husqvarna 372xp new score! need service manual  (Read 2152 times)

0 Members and 17 Guests are viewing this topic.

Offline UNCLEBEEF

  • 4 cube
  • **
  • Posts: 29
  • Karma: 3

  • Total Badges: 14
    Badges: (View All)
    One year Anniversary Apple User Mobile User Level 3 Karma Good 10 Posts
Re: husqvarna 372xp new score! need service manual
« Reply #20 on: March 23, 2013, 12:44:52 pm »
Hello, thought I would give an update on the saw. I received all the parts and installed them. started with a new 50mm meteor piston with a single caber ring. I made a scotchbrite flap wheel hone using a piece of pvc as a mandrel and ran a little oil in it while cleaning the cylinder, this really worked good to clean up the cylinder .i hand sanded the cylinder with a 600 grit wet/dry and oil, the nikisil is so hard I don't think this did anything. installed a new base gasket, rebuilt the carb, replaced the fuel line and filter. now i'm adding another port in the muffler and then it's run time! I've seen different methods of attaching the new shroud on the muffler. I used a thread setter to install to 5mm inserts in the muffler, hopefully this will allow easy removal for cleaning the screen later on. I do have a question on initial break in. do I need to baby it or put it in wood and tune? what method has worked best for you? any help or opinion is appreciated.

 

Related Topics

  Subject / Started by Replies Last post
1 Replies
561 Views
Last post April 28, 2012, 08:33:30 am
by Cut4fun .
0 Replies
390 Views
Last post November 19, 2012, 12:45:21 pm
by Cut4fun .
0 Replies
330 Views
Last post November 26, 2012, 05:43:09 pm
by Cut4fun .
2 Replies
470 Views
Last post January 23, 2013, 08:24:54 pm
by biggurn
7 Replies
557 Views
Last post March 25, 2013, 12:24:08 pm
by 660magnum
1 Replies
351 Views
Last post July 29, 2013, 12:26:12 pm
by Cut4fun .
2 Replies
387 Views
Last post May 07, 2018, 02:36:08 pm
by Cut4fun .
0 Replies
385 Views
Last post December 26, 2020, 07:38:41 am
by Cut4fun .
10 Replies
934 Views
Last post January 07, 2023, 09:56:48 am
by ray benson
4 Replies
256 Views
Last post April 04, 2022, 07:57:39 am
by Cut4fun .