« previous next »
Pages: [1]   Go Down

Author Topic: Husqvarna k760 speed problen  (Read 2251 times)

0 Members and 29 Guests are viewing this topic.

Offline

  • pruner
  • *
  • Posts: 1
  • Karma: 0

    • Total Badges: 5
    Badges: (View All)
    Search Poll Starter Level 1 Linux User Mobile User
Husqvarna k760 speed problen
« on: October 30, 2017, 10:56:39 am »
I have replaces the piston and sparplug but stays the same until time goes by then it warms up and cuts fine but if i run out of gas by the time i start it again is the same thing. 

Can it be a clutch problem?
Logged

Share on Bluesky Share on Facebook

Offline

  • Administrator
  • Nitro Hotsaw
  • *******
  • Posts: 24887
  • Karma: 665
  • OHIO REDNECK Saw Repair Getter Done
    • Redneck Chainsaw Repair

    • Total Badges: 53
    Badges: (View All)
    Tenth year Anniversary Nineth year Anniversary Level 8 Apple User Eighth year Anniversary 20000 Posts
Re: Husqvarna k760 speed problen
« Reply #1 on: October 30, 2017, 04:24:31 pm »
@3000 FPS has messed with these.
Logged

Offline

  • Moderator
  • Nitro Hotsaw
  • *******
  • Posts: 4709
  • Karma: 320
  • Location: Carpenter, Wyoming

    • Total Badges: 43
    Badges: (View All)
    Tenth year Anniversary Nineth year Anniversary Level 7 Eighth year Anniversary Seventh year Anniversary Sixth year Anniversary
Re: Husqvarna k760 speed problen
« Reply #2 on: October 30, 2017, 06:53:53 pm »
I would check the belt on it to make sure it is in good shape and has the correct tension.   Then I would check the clutch to make sure it is in good shape.   

If the engine is running ok but the blade has stopped spinning when cutting into concrete or pavers then it is not the carb. 
Logged
PP 505, 475, 445.
Pages: [1]   Go Up
« previous next »
 

Related Topics

  Subject / Started by Replies Last post
3 Replies
1807 Views 		Last post June 08, 2011, 10:26:25 pm
by mcbob
1 Replies
5297 Views 		Last post November 28, 2011, 11:44:35 am
by bloodontheice
34 Replies
9045 Views 		Last post August 02, 2014, 04:07:59 pm
by 630 red
38 Replies
9168 Views 		Last post February 13, 2019, 01:55:47 pm
by HolmenTree
22 Replies
61384 Views 		Last post April 16, 2016, 07:22:41 am
by jmester
2 Replies
3690 Views 		Last post September 15, 2017, 10:04:32 pm
by joe_indi
1 Replies
1816 Views 		Last post September 18, 2017, 08:38:44 pm
by 3000 FPS
2 Replies
5010 Views 		Last post January 07, 2018, 08:12:37 pm
by jmester
18 Replies
5499 Views 		Last post January 20, 2018, 08:15:54 pm
by mdavlee .
5 Replies
2466 Views 		Last post May 05, 2020, 09:30:13 am
by ray benson