Chainsaw Repair
Husqvarna - Stihl - Poulan - Jonsered - Dolmar chainsaws and more => Chainsaws not listed - Gas OPE => Topic started by: Cut4fun on April 25, 2025, 10:32:53 am
-
Tested 3 saws today using that Duke's chain to see.
IMO need a file to them out of the box but most wont bother to do that.
Farmertec G466 460 stock with base gasket and DP cover.
Standard bore Farmertec D cc aftermarket cylinder first cuts in maple dropped 2 months ago.
https://youtu.be/TAVPq64DHkk
-
Farmertec G466 460 76.5cc
Well let’s see how ole girl does now. Even gave a new dress. Thanks Smittys saw shop.
Cylinder from Fabcorp , Farmertec D cc standard bore.
Dukes chain to test with from Sawsalvage.
Piston a meteor I had from a failed attemt by them making a p for 475 2077
Been my grunt chit job saw for past 2 years when needed. One set up uses stihl carbide chain for 20" under ground root cutting.
Used for stumping this years with 32"
Hopefully lives up to song playing as I buttoned it up. Bad to the bone.
-
Farmertec G466 D cc cylinder stock bore is sweet looking.
Meteor piston kit.
Well that made it fun. Smoking a pork shoulder. While putting Farmertec G466 together.
I have one very suspect aftermarket cylinder fastener. So ordered 8 OEM ones to replace later.
Fired right up like nothing happened. She lives.
-
Where I had cut was higher then measured at flare of 48". Ended up cutting 46x45.
-
Stump chunked.
Farmertec G444 even stock with their DP muffler is a beast.
-
The outerwear and grease on seal did it's job.
-
G466 hung a ring in the transfer about 80% though the cut. Stock afm topend I put on it after testing oem D cc one.
Spline screw M6x30
9022 341 1370, 90223411370
This part replaces… - 9041 216 1370 90412161370
-
Got her stumped yesterday. G466 and G444 for the dirty work.
-
Stumper and sidekick reporting for duty.
48” across lower area I want to cut at.