Chainsaw Repair
Husqvarna - Stihl - Poulan - Jonsered - Dolmar chainsaws and more => McCulloch => Topic started by: mrcaptainbob on April 18, 2011, 12:34:07 am
-
How do I get the manual oiler rod/shaft out? It appears the knob handle is broken and that the rod is also not connected. Do I need to disassemble the whole saw to get at this? Is there a better way? Other than that the saw runs fine.
-
There should be a little roll pin holding the button in .I think they are all the same but I'll look in a little bit to see .
-
I looked at several 10 series out in the shed .It's as I said a tiny little roll pin .
The easiest way is to either use a very thin punch or cut the point off a finish nail and tap the pin out the bottom .Then it's just a matter of pulling the button rod and all out .
-
Thanks, Al. I'll check into that Wednesday....
-
Say,yesterday I ordered a part from Scott and in looking over his site he has a complete button and shaft for a 10-10 for cheap .http://store.chainsawr.com/