Chainsaw Repair

Husqvarna - Stihl - Poulan - Jonsered - Dolmar chainsaws and more => Echo => Topic started by: Moosemcnally on March 01, 2014, 11:00:09 pm

Title: Echo CS 8000 P rebuild
Post by: Moosemcnally on March 01, 2014, 11:00:09 pm
Echo CS8000p.  Just got this saw and am going to get her running again. What is the propper gap tween the coil and fly wheel? Where can I find a new piston if need be? This is the old all metal orange bodied one! Who has parts?
Title: Re: Echo CS 8000 P rebuild
Post by: Cut4fun . on March 01, 2014, 11:07:10 pm
Just use a business card for coil gap.   

Never seen to many used pistons for 8000. New versions are domed. Just do echo 8000 search here for more info.
Title: Re: Echo CS 8000 P rebuild
Post by: 3000 FPS on March 03, 2014, 08:25:28 pm
Echo CS8000p.  Just got this saw and am going to get her running again. What is the propper gap tween the coil and fly wheel? Where can I find a new piston if need be? This is the old all metal orange bodied one! Who has parts?

I almost bought an 8000 at one time.   Keep us posted on how it turns out and your progress.  I am interested.
Title: Re: Echo CS 8000 P rebuild
Post by: sharkey on March 04, 2014, 04:24:39 am
8000p, had the largest carb and hopefully its still with the powerhead.  Walbro HDA-45 is listed as 16.7mm venturi but its much larger.  The hda45 choke bore is 22.5mm and throttle bore is 20mm.  You can tell this carb over the traditional hda as the casting is larger.  Walbro made that hda45 carb for this model only and since discontinued it.  Replaced by HDA-63 which looks to also be discontinued because the parts listing now shows the HDA-153?         

Your best bet on top end parts is the newest H/O quad port cylinder and piston combo under part number P050005320.  If you shop around you can find it for $150, includes cylinder, piston, rings, clips, wrist pin bearing and base gasket.  Otherwise, a flat top piston alone is available under part number P021005420. 

This would be a good time to split the cases and replace the bearings and seals when you upgrade the top end.  Flywheel air gap is .020-.025.  Like cut mentioned, use a business card to set the air gap. 

There are two different ignitions used on these depending on when they were made.  The modules and flywheels dont mix and match.  If your having trouble post some pics and we will help you figure out which set you have. 
Title: Re: Echo CS 8000 P rebuild
Post by: Moosemcnally on March 10, 2014, 09:10:57 pm
Got it running with no new parts needed. Someone shoved a screwdriver in the spark plug hole and it bound up the top ring on the piston. Carefully removed the ring, touched up the area that was binding  and off she went on the third pull!
Title: Re: Echo CS 8000 P rebuild
Post by: 3000 FPS on March 10, 2014, 09:48:26 pm
Alright sounds good.   Post a picture if you can.