Chainsaw Repair

Husqvarna - Stihl - Poulan - Jonsered - Dolmar chainsaws and more => Partner => Topic started by: farmboy196 on April 10, 2014, 12:31:09 am

Title: partner 950
Post by: farmboy196 on April 10, 2014, 12:31:09 am

I got a partner 950 and cant get it to seal on the intake of the carb side i got new parts on the intake side  5062219-01    5036780-01    5061335-01  these are the only parts that would make it seal i have lost a top end and i believe that was from getting air at the intake is there something i should know on how to get this to seal thanks for your time Gerald

Title: Re: partner 950
Post by: Cut4fun . on April 10, 2014, 01:05:33 pm

You talking about the K950?    Partner K950 IPL.  http://www.husqvarna.com/ddoc/PAII/PAII2002_AAaa/PAII2002_AAaa__106249364.pdf

Never had one come in to know anything sorry.

Title: Re: partner 950
Post by: Cut4fun . on April 10, 2014, 01:09:24 pm

Found a workshop manual = service manual   partner k65 k700 k950  k1250 96pages

http://www.lacountyfirefighters.org/items/Partner_Workshop_manual.pdf

Title: Re: partner 950
Post by: farmboy196 on April 14, 2014, 03:20:23 pm

yes a k950 and that is the correct manual



sorry so long to get back had a death in the famliy

Title: Re: partner 950
Post by: 3000 FPS on November 25, 2014, 12:17:42 am

I just worked on a K 950 at work last week and noticed the same problem with it not sealing good between the intake and carb.   I used some Yamabond on the surface and that seemed to work.   I was told the intake was NLA.   This particular saw uses a special bar and chain for cutting concrete.  I have never seen another like it.  The saw also had all three clutch springs broken which I replaced.  The business I work for actually had those in stock.  When done the saw seemed to start, run, and idle ok.