Chainsaw Repair

How To Basics - Carb Fixes + Mods - IPL and Service Manuals => IPL and Service Manuals => Topic started by: farmboy on February 22, 2016, 06:10:34 pm

Title: Husqvarna 335 XPT & 435-440 Workshop Manuals
Post by: farmboy on February 22, 2016, 06:10:34 pm
Husky has totally revamped website.  All I could find was Owners Manual.  Need both 335XPT & 435/440 WS manual.  Replacing fuel line in 335XPT.  Do you have to take engine out of case ??  This one has me stumped.  Don't want to totally disassemble if I don't have to.
Shep
Title: Re: Husqvarna 335 XPT & 435-440 Workshop Manuals
Post by: Cut4fun . on February 22, 2016, 06:50:37 pm
Check email for 335XPT SM

I cant remember on lines on my 338's.  :-[
Title: Re: Husqvarna 335 XPT & 435-440 Workshop Manuals
Post by: 660magnum on February 22, 2016, 07:53:37 pm
Look in email for 435/440 WSM
Title: Re: Husqvarna 335 XPT & 435-440 Workshop Manuals
Post by: 660magnum on February 22, 2016, 08:11:01 pm
The 435/440 are clamshell type strato charged engines

I have the IPL too if needed
Title: Re: Husqvarna 335 XPT & 435-440 Workshop Manuals
Post by: 660magnum on February 22, 2016, 08:46:58 pm
The Husqvarna USA website is somewhat confusing.

In spite of the label in the support section (Downloads) saying "owners manuals", when you click on it, the IPL lists come up.

Workshop Manuals have to be found elsewhere.
Title: Re: Husqvarna 335 XPT & 435-440 Workshop Manuals
Post by: farmboy on February 22, 2016, 09:51:19 pm
Thanks guys.  On the 335 it's what I was afraid of you have to dang near dismantle it to change the fuel line.  Thanks Jim I have 435/440 IPL.  The 435 is the one I posted about low comp. 93 psi.  Nothing wrong w/piston, cyl. or ring. cyl. to case screws were loose and missing.
Shep

Got ticked off and quit.  For some reason It wouldn't load the owners manual page.  Will try it again Thank you.
Title: Re: Husqvarna 335 XPT & 435-440 Workshop Manuals
Post by: 660magnum on February 22, 2016, 09:57:41 pm
LMK if you want me to re-send it?

I can put it in a cloud and you can download from there if your Email set up is flakey?
Title: Re: Husqvarna 335 XPT & 435-440 Workshop Manuals
Post by: 660magnum on February 22, 2016, 10:03:40 pm
Being as you work on two strokes all the time  . . .

I may have already posted this?

Cut was working on a 272 that wouldn't run right but had good static compression. It ran like low compression.

The ring had rounded edges at the PTO side transfer because of a aftermarket cylinder.