Chainsaw Repair
Husqvarna - Stihl - Poulan - Jonsered - Dolmar chainsaws and more => Echo => Topic started by: Ian on December 28, 2016, 08:26:25 am
-
I have a CS660EVL with 24" bar. It starts and runs OK but after say 20 minutes use it suddenly dies just as if I had hit the kill switch. If I remove the spark plug and spin the motor, there is no spark. When it cools down it will start and run again for a while, as though nothing had happened. I am assuming its an ignition module failure which is bad news as the module seems to be an obselete part. Any thoughts, and specifically, does anyone know if a different module can be made to fit. It's way too good a saw to throw away! Thanks.
-
I have a CS660EVL with 24" bar. It starts and runs OK but after say 20 minutes use it suddenly dies just as if I had hit the kill switch. If I remove the spark plug and spin the motor, there is no spark. When it cools down it will start and run again for a while, as though nothing had happened. I am assuming its an ignition module failure which is bad news as the module seems to be an obselete part. Any thoughts, and specifically, does anyone know if a different module can be made to fit. It's way too good a saw to throw away! Thanks.
can u post a imagge of the coil i have coils with no part numbers
-
I have been trying to find an echo 660 ignition coil and saw this thread, any chance you still have any?