Chainsaw Repair

Guy helped me compare a Farmertec G255E easy start to a Stihl 250C easy start.

The farmertec 255/250 version of easy start, works like the 180 version and also looks like it too.

Comparing because the cost for oem parts for this easy start stuff is ridiculous.

I ended up running 3x5 echo on everything. Way better then that crap I took out.

But did notice the 2 for purge were close to being loose but worked.

If I had the smaller I would have used it.But easy enough to change those 2 purge ones.

Stihl oem line sizes for such.


0000 930 2802  00009302802

We are being teased. But V-modest said look for them on ebay as early as March. 

They promised us a rear handle clone 2511 last year but hit some road blocks. Over on chainsaw repair group fb.

Our V-modest dealer here should be able to get some sooner when released. He is teasing us with a 10 part pic release he was sent of whole saw I would guess or has a prototype one. 

Only pic we seen teased at us. I was able to tell what it was since owning one in OEM. If I am wrong oh well I tried.

Just need a good day to test and check tune. Before calling it good to take to dad someday.

Being the Farmertec muffler is more open like 025 muffler. Whole square area open and deeper outer slits exiting.
I also used the gasket between the heat shield and muffler.
None was there on 250 set up.

So want to make sure where is at since last session with the 250 muffler.

Also some heat tape layers under and side of plastics where old muffler was ran loose and melted up some.

It is super light so I'm leaning toward  magnesium. Thanks for the  reply.

Chris