Author Topic: cs2240s wont start  (Read 3168 times)

0 Members and 21 Guests are viewing this topic.

Offline 3000 FPS

  • Moderator
  • Nitro Hotsaw
  • *******
  • Posts: 4706
  • Karma: 320
  • Location: Carpenter, Wyoming

  • Total Badges: 43
    Badges: (View All)
    Tenth year Anniversary Nineth year Anniversary Level 7 Eighth year Anniversary Seventh year Anniversary Sixth year Anniversary
Re: cs2240s wont start
« Reply #30 on: February 07, 2016, 10:08:44 am »
It sounds like it could be the carburetor.   Try adjusting the L side out by half a turn and then see if there is any improvement.   The H is for wide open throttle and the L is for idle and transition to WOP.   If you get it to rev then make sure you adjust the H for the 4 stroking sound at WOP throttle and then when you put it in wood it will smooth out to 2 stroking.   

If the carb adjustments have no effect then you must have an air leak in it somewhere and you need to start checking things.
PP 505, 475, 445.

 

Related Topics

  Subject / Started by Replies Last post
4 Replies
1023 Views
Last post January 05, 2012, 08:44:51 am
by Al Smith
5 Replies
822 Views
Last post December 06, 2013, 07:42:56 pm
by Al Smith
80 Replies
4816 Views
Last post February 13, 2014, 02:37:33 pm
by mastercraftka
5 Replies
453 Views
Last post January 09, 2014, 08:55:36 am
by sharkey
19 Replies
1174 Views
Last post February 21, 2014, 08:16:06 pm
by jmester
MS360 Pro wont start

Started by ears54 « 1 2 » Stihl

10 Replies
1361 Views
Last post August 16, 2015, 03:37:13 pm
by Cut4fun .
2 Replies
496 Views
Last post September 12, 2015, 09:44:05 pm
by jrdplowing
2 Replies
619 Views
Last post December 30, 2015, 03:58:15 pm
by Cat-Face Timber
4 Replies
1405 Views
Last post November 27, 2016, 08:59:14 pm
by mdavlee .
11 Replies
3718 Views
Last post June 05, 2017, 02:48:32 pm
by 3000 FPS