Author Topic: Mcculloch SP81  (Read 259 times)

0 Members and 0 Guests are viewing this topic.

Offline PM1000

  • 3 cube
  • *
  • Posts: 5
  • Karma: 0
Mcculloch SP81
« on: February 28, 2016, 10:37:02 pm »
I recently acquired an sp81. I'm wondering why there is only one mixture adjustment screw on the carb. I'm assuming it's for high speed adjustments and there is no adjustment for low speed mixture ?

Share on Facebook Share on Twitter


Offline PM1000

  • 3 cube
  • *
  • Posts: 5
  • Karma: 0
Re: Mcculloch SP81
« Reply #1 on: February 29, 2016, 10:50:37 am »
here's a picture of the carb

Offline PM1000

  • 3 cube
  • *
  • Posts: 5
  • Karma: 0
Re: Mcculloch SP81
« Reply #2 on: February 29, 2016, 10:53:56 am »
the only adjustment is the large screw at the top left corner of the picture, where the H and L adjustments normally are  are blocked off with brass plugs.

Offline PM1000

  • 3 cube
  • *
  • Posts: 5
  • Karma: 0
Re: Mcculloch SP81
« Reply #3 on: February 29, 2016, 11:23:31 am »
i see a walbro sdc 65 on ebay that appears to be fully adjustable, it says it is off of a 10-10a, do you think it would be large enough to run on the sp81?

 

Related Topics

  Subject / Started by Replies Last post
24 Replies
1560 Views
Last post June 01, 2013, 12:24:49 pm
by HMLT360Pro
13 Replies
663 Views
Last post June 14, 2013, 09:00:48 pm
by Al Smith
8 Replies
331 Views
Last post May 24, 2013, 12:14:28 pm
by HMLT360Pro
11 Replies
826 Views
Last post November 16, 2013, 05:12:44 am
by Al Smith
2 Replies
222 Views
Last post December 10, 2013, 08:12:02 pm
by jmester
4 Replies
886 Views
Last post July 30, 2017, 03:38:28 pm
by Al Smith
mcculloch 110

Started by Cut4fun . « 1 2 » McCulloch

13 Replies
733 Views
Last post May 09, 2015, 12:01:24 pm
by Cut4fun .
3 Replies
24 Views
Last post July 26, 2014, 10:32:30 am
by Cut4fun .
6 Replies
252 Views
Last post April 08, 2015, 07:29:35 pm
by Eccentric
4 Replies
235 Views
Last post July 23, 2015, 04:39:14 pm
by Cut4fun .