Author Topic: Craftsman 32cc Mini Tiller fix  (Read 2123 times)

0 Members and 0 Guests are viewing this topic.

Offline Cut4fun .

  • Administrator
  • Nitro Hotsaw
  • *******
  • Posts: 18586
  • Karma: 362
  • OHIO REDNECK Saw Repair Getter Done
    • Redneck Chainsaw Repair
Re: Craftsman 32cc Mini Tiller fix
« Reply #10 on: July 06, 2014, 04:16:02 pm »
Thanks Jim for the delivery of Mac and Ryobi trimmers.   The one Mac you seen get to run that I said I could redneck to work was a failure. I ended up ruining the recoil shortening it up as far as I needed to reach the tiller shaft. strike 1
So I dig back in the Ryobi PH that had broken recoil. Another no go after removal. The whole bottom end is totally different then the Ryobi tiller motor one.  Couldnt believe that one.  So went to try and do a switch and got all but 1 seized bolt out. 
Time to walk away and come back later.

Thanks again and enjoyed the small talk.

REDNECK Saw Repair Getter Done

 

Related Topics

  Subject / Started by Replies Last post
2 Replies
477 Views
Last post April 03, 2011, 10:03:25 am
by Cut4fun
54 Replies
2061 Views
Last post July 20, 2016, 06:31:43 pm
by Cut4fun .
1 Replies
664 Views
Last post February 23, 2012, 03:09:57 pm
by Old Iron Logging
2 Replies
1020 Views
Last post July 18, 2012, 01:40:02 pm
by Cut4fun .
25 Replies
1587 Views
Last post August 25, 2015, 11:27:14 am
by Cut4fun .
6 Replies
191 Views
Last post November 12, 2013, 05:21:48 pm
by 660magnum
11 Replies
307 Views
Last post March 27, 2015, 10:18:20 pm
by dannyupsolate
2 Replies
92 Views
Last post September 12, 2015, 03:49:25 pm
by Cut4fun .
5 Replies
122 Views
Last post June 17, 2016, 10:03:02 am
by sweepleader
8 Replies
40 Views
Last post September 23, 2017, 12:04:50 pm
by Cut4fun .