« previous next »
Pages: 1 2 3 4 5 [6] 7 8   Go Down

Author Topic: crankcase vol. (no drilling involved)  (Read 2243 times)

0 Members and 64 Guests are viewing this topic.

Offline 1manband

  • Nitro Hotsaw
  • *******
  • Posts: 759
  • Karma: 52

    • Total Badges: 22
    Badges: (View All)
    Third year Anniversary Level 5 500 Posts Apple User Second year Anniversary One year Anniversary
Re: crankcase vol. (no drilling involved)
« Reply #50 on: March 08, 2016, 07:20:02 pm »
first photo is motor A from paper again, yellow highlight, showing that everything lines up fine.

second photo is saw motor set for 5500 rpm.  the CCR is off.

third photo is the same saw motor now set at 4500 rpm.  there is about a 1000 rpm spread on either side of 5500. but far off from 4500.
Logged
hiatus
Pages: 1 2 3 4 5 [6] 7 8   Go Up
« previous next »
 

Related Topics

  Subject / Started by Replies Last post
12 Replies
1908 Views 		Last post May 08, 2011, 06:11:27 am
by Spike60
365 crankcase

Started by chainsman1 « 1 2 » Wanted

18 Replies
1262 Views 		Last post October 03, 2011, 09:31:46 pm
by chainsman1
4 Replies
847 Views 		Last post July 01, 2013, 11:42:19 am
by SawTroll
Crankcase

Started by jmester Wanted

4 Replies
285 Views 		Last post February 19, 2014, 06:23:01 am
by jmester
3 Replies
226 Views 		Last post May 18, 2015, 12:35:03 am
by Stihlboy
066 crankcase

Started by jmester « 1 2 » Stihl

12 Replies
725 Views 		Last post August 08, 2015, 10:05:48 pm
by jmester
0 Replies
185 Views 		Last post September 28, 2019, 08:34:21 pm
by Ron
4 Replies
313 Views 		Last post January 06, 2020, 12:34:29 pm
by 3000 FPS
0 Replies
219 Views 		Last post February 05, 2020, 04:19:38 pm
by Cut4fun .
0 Replies
123 Views 		Last post April 12, 2023, 11:21:40 am
by Cut4fun .