Author Topic: cylinder / piston interchange  (Read 1124 times)

0 Members and 1 Guest are viewing this topic.

Offline Cut4fun .

  • Administrator
  • Nitro Hotsaw
  • *******
  • Posts: 22502
  • Karma: 586
  • OHIO REDNECK Saw Repair Getter Done
    • Redneck Chainsaw Repair
Re: cylinder / piston interchange
« Reply #10 on: January 12, 2016, 08:11:45 pm »
My Craftsman 3.7 was 60cc in the PP365 yellow, green 3500 with Chrome cylinder.
REDNECK Saw Repair Getter Done

Offline jcsmith

  • 5 cube
  • ***
  • Posts: 76
  • Karma: 7
  • Certified Shadetree Mechanic
  • Location: Northampton Co, PA
Re: cylinder / piston interchange
« Reply #11 on: January 12, 2016, 10:33:49 pm »
 Thanks again for the responses.Some great info. I remember that post about the chrome or plain bore. Thanks for the refresh.
   Appreciate the links Cut4fun.
  I've been using Opti and Pro Mix single ratio oils with good results. What oil do y'all use?  I'll have to do a search on 2 stroke oils.

  Thanks fellas, Chris
As you slide down the Banister of Life, may the splinters point in the right direction

Offline 3000 FPS

  • Moderator
  • Nitro Hotsaw
  • *******
  • Posts: 4532
  • Karma: 284
  • Location: Carpenter, Wyoming
Re: cylinder / piston interchange
« Reply #12 on: January 12, 2016, 11:14:58 pm »
Thanks again for the responses.Some great info. I remember that post about the chrome or plain bore. Thanks for the refresh.
   Appreciate the links Cut4fun.
  I've been using Opti and Pro Mix single ratio oils with good results. What oil do y'all use?  I'll have to do a search on 2 stroke oils.

  Thanks fellas, Chris

I use a 100% synthetic oil.  It does not matter the brand but I also mix at 32 to 1.
PP 505, 475, 445.

 

Related Topics

  Subject / Started by Replies Last post
0 Replies
233 Views
Last post May 24, 2012, 08:20:22 pm
by MP5N
19 Replies
531 Views
Last post September 09, 2013, 09:51:10 pm
by doreadeal
12 Replies
244 Views
Last post December 15, 2014, 05:25:46 am
by Eccentric
0 Replies
58 Views
Last post March 04, 2015, 08:35:50 am
by jmester
4 Replies
157 Views
Last post March 10, 2015, 10:43:39 am
by 660magnum
0 Replies
127 Views
Last post September 26, 2015, 10:29:23 pm
by 660magnum
7 Replies
409 Views
Last post January 18, 2016, 12:54:40 pm
by randy_das
5 Replies
162 Views
Last post May 09, 2017, 09:44:40 am
by Nathaniel Vansickle
1 Replies
539 Views
Last post September 20, 2018, 04:08:33 pm
by Cut4fun .
3 Replies
155 Views
Last post April 01, 2020, 11:15:27 am
by pleasant