Author Topic: Key Poulan saws  (Read 290 times)

0 Members and 0 Guests are viewing this topic.

Offline Cut4fun .

  • Administrator
  • Nitro Hotsaw
  • *******
  • Posts: 20116
  • Karma: 429
  • OHIO REDNECK Saw Repair Getter Done
    • Redneck Chainsaw Repair
Key Poulan saws
« on: October 13, 2014, 01:28:16 pm »
Just part of Key Poulan collection.

Key = Original 1940s-50s Poulan K, KD, B, F, H, and (4) 2-man 44 saws. Rare Poulan boat motor prototype on 2nd shelf from the bottom on the middle unit. Beaird-Poulan saws on the lower shelves and floor. These aren't my cream of the crop except the boat prototype. It's nice to know what I have though.

REDNECK Saw Repair Getter Done

Social Buttons

Like Like x 1 View List

Offline Eccentric

  • Moderator
  • Nitro Hotsaw
  • *******
  • Posts: 2105
  • Karma: 215
  • Magnesium and Iron.
  • Location: Northern California.
Re: Key Poulan saws
« Reply #1 on: October 19, 2014, 02:19:33 am »
Very cool.
-Aaron

For older saws:
Tune the H side so that it 4-strokes (burbles) at WOT unloaded and just cleans up when under load.
When you lift cutting load, the saw should immediately revert to 4-stroking.  Fine tune the transition point for the wood you're cutting.

Offline timber

  • 3 cube
  • *
  • Posts: 6
  • Karma: 1
  • Location: Richmond VA
Re: Key Poulan saws
« Reply #2 on: April 01, 2017, 06:46:32 pm »
cool
key nice guy

Offline old 040

  • 4 cube
  • **
  • Posts: 67
  • Karma: 16
Re: Key Poulan saws
« Reply #3 on: April 03, 2017, 06:06:05 am »
Nice, any close ups of that promo boat motor?

 

Related Topics

  Subject / Started by Replies Last post
3 Replies
366 Views
Last post September 26, 2011, 09:53:17 pm
by Cut4fun .
26 Replies
1177 Views
Last post September 13, 2012, 11:12:37 am
by SawTroll
13 Replies
1099 Views
Last post January 17, 2014, 05:26:32 pm
by bustedknuckles
5 Replies
396 Views
Last post January 27, 2016, 09:04:28 pm
by 3000 FPS
3 Replies
566 Views
Last post July 13, 2015, 12:44:12 am
by Eccentric
23 Replies
2332 Views
Last post December 18, 2014, 01:38:25 pm
by Cut4fun .
8 Replies
754 Views
Last post June 17, 2014, 06:47:55 am
by Spike60
9 Replies
332 Views
Last post June 22, 2014, 07:02:42 pm
by 3000 FPS
15 Replies
939 Views
Last post May 10, 2018, 05:07:05 pm
by Eccentric
14 Replies
351 Views
Last post December 28, 2015, 04:30:20 pm
by jmester