Author Topic: Poulan 315 50th anniversary edition  (Read 841 times)

0 Members and 0 Guests are viewing this topic.

Offline Eccentric

  • Moderator
  • Nitro Hotsaw
  • *******
  • Posts: 2112
  • Karma: 217
  • Magnesium and Iron.
  • Location: Northwestern Wyoming
Re: Poulan 315 50th anniversary edition
« Reply #20 on: July 06, 2018, 02:31:50 am »
Thread Revival!
I got a PP 315 50th Ann in a lot of saws I bought. Seems like it will be a competent saw. Donít know too much yet - need new clutch, sprocket and starter pulley.
How do they pull 18ď .325?
Thinking about trying 3/8LP. It has a K041 bar but bet A041 will work.
Clutch drum is 67mm OD and bearing is 13mm OD. Seeing if I can find a rim sprocket like that to take a 3/8LP rim.

Don't know.  I don't think I know anyone that has ran a 49cc PP315, PP310, or 3050.  The 46cc saws will run an 18" .325 pitch bar fairly well, especially after the muffler's opened up a bit.

Offline Cut4fun .

  • Administrator
  • Nitro Hotsaw
  • *******
  • Posts: 22498
  • Karma: 586
  • OHIO REDNECK Saw Repair Getter Done
    • Redneck Chainsaw Repair
Re: Poulan 315 50th anniversary edition
« Reply #21 on: July 16, 2020, 09:56:10 am »
Guy listing this poulan 315 50th on CRG FS

REDNECK Saw Repair Getter Done

 

Related Topics

  Subject / Started by Replies Last post
17 Replies
790 Views
Last post May 24, 2017, 06:52:22 pm
by 3000 FPS
Poulan 445

Started by 3000 FPS « 1 2 ... 19 20 » Poulan

191 Replies
5647 Views
Last post April 02, 2021, 08:17:44 am
by Cut4fun
7 Replies
640 Views
Last post April 13, 2014, 08:11:42 pm
by Cut4fun .
0 Replies
192 Views
Last post October 02, 2012, 11:36:18 am
by mweba
Poulan 395

Started by 3000 FPS « 1 2 3 » Poulan

23 Replies
1247 Views
Last post January 05, 2013, 09:09:29 pm
by 3000 FPS
4 Replies
630 Views
Last post November 23, 2012, 12:28:15 am
by Andyshine77
23 Replies
1439 Views
Last post November 02, 2015, 04:36:50 pm
by Cut4fun .
11 Replies
1013 Views
Last post October 06, 2013, 10:12:00 pm
by stihls066
3 Replies
142 Views
Last post September 25, 2017, 08:10:47 am
by pete
0 Replies
178 Views
Last post October 21, 2017, 10:25:14 pm
by Cut4fun .