Author Topic: Poulan Woodshark 1975 over revving at idle  (Read 782 times)

0 Members and 6 Guests are viewing this topic.

Offline dannyupsolate

  • Piped Saw
  • *****
  • Posts: 328
  • Karma: 28

  • Total Badges: 18
    Badges: (View All)
    Third year Anniversary Karma Good Level 4 Second year Anniversary Poll Voter One year Anniversary
Re: Poulan Woodshark 1975 over revving at idle
« Reply #10 on: October 14, 2016, 04:51:45 pm »
looks like a good deal. most likely aluminum cylinder saw so be sure to use non ethanol fresh gas with good name brand 2 cycle oil. your new saw may need a half turn or so out on the H screw as some are set lean from factory. make sure it runs rich enough as that is the life of your saw. with a little care they last very well.
Like Like x 1 View List

Offline Cut4fun .

  • Administrator
  • Nitro Hotsaw
  • *******
  • Posts: 23708
  • Karma: 664
  • OHIO REDNECK Saw Repair Getter Done
    • Redneck Chainsaw Repair

  • Total Badges: 53
    Badges: (View All)
    Tenth year Anniversary Nineth year Anniversary Level 8 Apple User Eighth year Anniversary 20000 Posts
Re: Poulan Woodshark 1975 over revving at idle
« Reply #11 on: October 14, 2016, 06:02:29 pm »
Like said check the tune from get go.

Also the fuel line is usually crap in these oem. So after a year pay attention. 


Offline dannyupsolate

  • Piped Saw
  • *****
  • Posts: 328
  • Karma: 28

  • Total Badges: 18
    Badges: (View All)
    Third year Anniversary Karma Good Level 4 Second year Anniversary Poll Voter One year Anniversary
Re: Poulan Woodshark 1975 over revving at idle
« Reply #12 on: October 14, 2016, 07:03:38 pm »
@ cut4fun that runny snot fuel line you found was worst thing I have seen. disgusting

 

Related Topics

  Subject / Started by Replies Last post
3 Replies
845 Views
Last post March 09, 2011, 07:47:49 pm
by hamish
16 Replies
2058 Views
Last post November 02, 2013, 11:05:19 pm
by Oliver1655
5 Replies
538 Views
Last post December 31, 2012, 04:26:16 pm
by Cut4fun
3 Replies
668 Views
Last post February 15, 2013, 04:24:17 pm
by Cut4fun .
3 Replies
361 Views
Last post July 13, 2017, 11:11:28 am
by richief
6 Replies
420 Views
Last post November 15, 2013, 08:19:21 pm
by Cut4fun
10 Replies
680 Views
Last post November 01, 2014, 11:20:01 am
by ed 46
6 Replies
465 Views
Last post November 06, 2017, 09:43:35 pm
by 3000 FPS
0 Replies
240 Views
Last post March 26, 2018, 03:35:00 pm
by dano
7 Replies
2397 Views
Last post September 14, 2020, 08:12:33 am
by Cut4fun .