Author Topic: Finally Have My Ported Earthquake G3800 Clone Running Right!  (Read 2097 times)

0 Members and 43 Guests are viewing this topic.

Offline Chris-PA

  • 6 cube
  • ****
  • Posts: 209
  • Karma: 32

  • Total Badges: 21
    Badges: (View All)
    Level 5 Third year Anniversary Second year Anniversary 100 Posts 50 Posts Level 4
Re: Finally Have My Ported Earthquake G3800 Clone Running Right!
« on: December 13, 2015, 04:54:50 pm »
Ran it a bit clearing brush and bucking a bit of ash.  Throttle response was nice while cutting brush.  Took this video:



Once it got loaded in the cut it was running around 10,500rpm.  Seemed to run pretty clean - at least I didn't stink too bad like exhaust after running it today. 

 

Related Topics

  Subject / Started by Replies Last post
7 Replies
1020 Views
Last post March 28, 2015, 09:32:30 pm
by Cut4fun .
1 Replies
288 Views
Last post November 11, 2014, 08:58:49 pm
by Cut4fun .
2 Replies
526 Views
Last post March 28, 2015, 09:29:02 pm
by Cut4fun .
8 Replies
629 Views
Last post October 09, 2016, 07:08:42 pm
by Cut4fun .
0 Replies
329 Views
Last post October 02, 2019, 11:36:57 pm
by Philbert
6 Replies
760 Views
Last post September 23, 2022, 12:04:42 pm
by Cut4fun .
1 Replies
312 Views
Last post April 25, 2021, 04:46:34 pm
by Cut4fun .
2 Replies
621 Views
Last post October 01, 2021, 06:26:26 pm
by The Ripper
0 Replies
372 Views
Last post October 26, 2022, 02:17:52 am
by joe_indi
0 Replies
255 Views
Last post December 27, 2022, 04:16:04 pm
by Cut4fun .