Author Topic: 372 won't rev past idle  (Read 375 times)

0 Members and 24 Guests are viewing this topic.

Offline Fatkid

  • pruner
  • *
  • Posts: 1
  • Karma: 0

  • Total Badges: 3
    Badges: (View All)
    Level 1 Apple User Mobile User
372 won't rev past idle
« on: May 25, 2018, 09:13:32 pm »
I have a 372 that won't rev past idle- just a stubborn put-put-put.... Finally stalls.
This saw was a 365 that I put a 372 head and piston on last year and it ran great.
I ordered and just installed a new carb complete, ignition module, plug.
Same issue . The air filter is off, muffler off- no better. Piston looks fine through the ports... I'm stumped

Share on Facebook Share on Twitter


Offline farmboy

  • Moderator
  • Nitro Hotsaw
  • *******
  • Posts: 1170
  • Karma: 150
  • Location: Hayesville, NC

  • Total Badges: 31
    Badges: (View All)
    Level 6 Eighth year Anniversary Seventh year Anniversary Sixth year Anniversary 1000 Posts Old Browser
Re: 372 won't rev past idle
« Reply #1 on: May 25, 2018, 10:36:47 pm »
Check flywheel key.  Just had one spin flywheel died in cut.
Shep

 

Related Topics

  Subject / Started by Replies Last post
41 Replies
2057 Views
Last post April 19, 2020, 12:08:54 pm
by Cut4fun .
3 Replies
846 Views
Last post March 09, 2011, 07:47:49 pm
by hamish
4 Replies
3856 Views
Last post February 20, 2013, 01:47:20 pm
by Cut4fun .
3 Replies
668 Views
Last post February 15, 2013, 04:24:17 pm
by Cut4fun .
6 Replies
420 Views
Last post November 15, 2013, 08:19:21 pm
by Cut4fun
7 Replies
413 Views
Last post March 03, 2014, 07:57:30 pm
by maxmag
5 Replies
432 Views
Last post February 11, 2015, 06:11:53 pm
by 3000 FPS
5 Replies
855 Views
Last post June 21, 2015, 12:59:48 pm
by Cut4fun .
1 Replies
598 Views
Last post August 17, 2016, 07:27:27 pm
by Cut4fun .
2 Replies
328 Views
Last post December 14, 2022, 02:31:59 pm
by jfulford1