Author Topic: How to video thread  (Read 7489 times)

0 Members and 46 Guests are viewing this topic.

Offline Al Smith

  • Moderator
  • Nitro Hotsaw
  • *******
  • Posts: 2779
  • Karma: 181

  • Total Badges: 34
    Badges: (View All)
    Tenth year Anniversary Nineth year Anniversary Eighth year Anniversary Level 6 Seventh year Anniversary Sixth year Anniversary
Re: How to video thread
« on: March 29, 2011, 10:11:06 am »
Usually a mechanical puller will loosen any flywheel . A little tip that may apply in some stuborn cases .Apply a little heat right around the hub with a heat gun .

The aluminum flywheel will expand at a much greater rate than the steel crankshaft .

Another is when using a puller ,take  good tension then strike the puller with some impact .This will often pop them loose .All you have to do is move it off the taper just a very little bit .

I've seen a lot of small engine crankshafts get ruined from people beating on the nut with a ball peen hammer .

 

Related Topics

  Subject / Started by Replies Last post
1 Replies
617 Views
Last post February 23, 2013, 11:55:26 am
by Cut4fun .
15 Replies
1613 Views
Last post December 07, 2013, 03:39:46 pm
by Arrow13
5 Replies
1341 Views
Last post August 18, 2023, 08:47:16 am
by Cut4fun
12 Replies
680 Views
Last post January 31, 2014, 11:43:30 am
by KilliansRedLeo
9 Replies
783 Views
Last post April 02, 2014, 10:48:15 pm
by Philbert
63 Replies
1663 Views
Last post July 11, 2014, 12:40:18 pm
by JohnG28
7 Replies
747 Views
Last post February 17, 2015, 09:13:42 pm
by mcbob
3 Replies
435 Views
Last post April 24, 2015, 02:51:01 pm
by Eccentric
12 Replies
1011 Views
Last post February 18, 2016, 07:45:29 pm
by dannyupsolate
1 Replies
390 Views
Last post August 01, 2019, 07:33:32 pm
by Midpines