Author Topic: Homemade Carb adjusting tools  (Read 1771 times)

0 Members and 70 Guests are viewing this topic.

Offline rayvil01

  • 5 cube
  • ***
  • Posts: 137
  • Karma: 19

  • Total Badges: 27
    Badges: (View All)
    Seventh year Anniversary Sixth year Anniversary Karma Good Fifth year Anniversary Fourth year Anniversary Third year Anniversary
Re: Homemade Carb adjusting tools
« on: January 20, 2015, 05:17:59 pm »
I've been working on this old Dolmar 112.  The High and Low adjustments were straight-tipped screws on springs.  That part of the job was a dream.  No limiters.  No funny-shaped screws.  Old School. 

Man, I wish they had never gotten away from that. 

 

Related Topics

  Subject / Started by Replies Last post
37 Replies
6305 Views
Last post February 21, 2014, 03:18:14 am
by fordfairlane78
12 Replies
1392 Views
Last post November 25, 2012, 09:54:08 pm
by Al Smith
5 Replies
836 Views
Last post October 12, 2012, 10:56:50 pm
by Cut4fun .
2 Replies
521 Views
Last post January 03, 2013, 12:50:50 pm
by Cut4fun
6 Replies
1458 Views
Last post February 03, 2013, 11:18:24 am
by man of stihl
8 Replies
4043 Views
Last post July 29, 2017, 10:12:16 am
by Cut4fun .
9 Replies
903 Views
Last post June 18, 2014, 09:21:10 pm
by farmboy
31 Replies
1369 Views
Last post November 25, 2015, 10:07:18 am
by Cut4fun .
0 Replies
471 Views
Last post November 25, 2015, 10:04:52 am
by Cut4fun .
3 Replies
618 Views
Last post July 22, 2019, 02:23:35 pm
by Cut4fun .