Chainsaw Repair

44DL chain
3/8 - 7 tooth rim

Is that where a 44dl fits, shown?  Also oiler holes line up?   Do you have a 45dl to test fit?

That looks sweet and way better then my hack redneck job I would have done.

Sweet Thank You for doing this and saving me all the work.

I wore my ole azz out today doing these chains today.  Like 25 on off chains,  was on 3rd tank and 2 or so bar oil.   

Was fun though.  Just got in a rhythm.

The tensioner hole in the tail closest to the sprocket is for the small mount. The two forward holes are for the large mount it should work no problem. I will send it out tomorrow. once you have it if you need to mod it more no worries. It sure does look funny to have that small of a bar on a 026. I will pay shipping to you no worries. Thanks for putting this chain build off together. I am interested to see the results from today but it maybe a whole different story with 50cc driving the chain.

Thank you. The hardest part is trying to keep the slot straight up the bar. I made a template on the 3003 bar tail. Line up the template with end of the bar and marked out the width and length of the slot. Also marked the tensioner holes. I had to measure out for the oil holes. Used a grinder with a cut off wheel for the rough in. Then did the rest with a flat file. Fun little project.