« previous next »
Pages: [1]   Go Down

Author Topic: green weedeater  (Read 1396 times)

0 Members and 56 Guests are viewing this topic.

Offline

  • Piped Saw
  • *****
  • Posts: 328
  • Karma: 28

    • Total Badges: 18
    Badges: (View All)
    Third year Anniversary Karma Good Level 4 Second year Anniversary Poll Voter One year Anniversary
green weedeater
« on: March 24, 2016, 04:53:08 pm »
started with 7 of these got 6 going . all i learned is when you think carburetor is clean and they don't run right clean it again. went to 50% purple power in ultrasonic cleaner. unlike mtd brand I did not run into internal engine problems. number 7 seems to be out of time but I got to work on saws now. 100% purple power eats on the aluminum.
Logged

Share on Bluesky Share on Facebook

Offline

  • Moderator
  • Nitro Hotsaw
  • *******
  • Posts: 4709
  • Karma: 320
  • Location: Carpenter, Wyoming

    • Total Badges: 43
    Badges: (View All)
    Tenth year Anniversary Nineth year Anniversary Level 7 Eighth year Anniversary Seventh year Anniversary Sixth year Anniversary
Re: green weedeater
« Reply #1 on: March 24, 2016, 11:54:17 pm »
Even the 50% purple power will eat the aluminum if you leave it in there long enough.  I never use it for carbs.
Logged
PP 505, 475, 445.

Offline

  • Piped Saw
  • *****
  • Posts: 328
  • Karma: 28

    • Total Badges: 18
    Badges: (View All)
    Third year Anniversary Karma Good Level 4 Second year Anniversary Poll Voter One year Anniversary
Re: green weedeater
« Reply #2 on: March 25, 2016, 11:29:02 am »
yes  you are correct don't leave them in it over an hour and rinse in water. put together get fuel mix in quick.  my whole idea was to speed up process . if you gonna put on shelf a while spray with wd40 or similar product, inside and outside.
Logged
Pages: [1]   Go Up
« previous next »
 

Related Topics

  Subject / Started by Replies Last post
25 Replies
8371 Views 		Last post December 20, 2011, 07:03:15 am
by Cut4fun .
3 Replies
9332 Views 		Last post June 29, 2012, 12:09:17 pm
by SawTroll
2 Replies
2234 Views 		Last post July 08, 2015, 05:02:35 pm
by Cut4fun .
2 Replies
1712 Views 		Last post July 27, 2014, 10:47:31 am
by JohnG28
13 Replies
4145 Views 		Last post December 07, 2014, 05:51:30 pm
by Cut4fun .
4 Replies
3309 Views 		Last post April 12, 2016, 06:30:34 pm
by dannyupsolate
0 Replies
679 Views 		Last post February 26, 2018, 09:02:23 am
by Cut4fun .
0 Replies
846 Views 		Last post June 15, 2020, 09:12:00 am
by Cut4fun .
4 Replies
1390 Views 		Last post February 11, 2021, 09:59:48 am
by muzzleblastm38
0 Replies
1654 Views 		Last post October 30, 2024, 09:18:26 am
by Cut4fun .