Chainsaw Repair

Well I got it together earlier this week. Runs pretty even with an air leak. Set the tune and went and did some cookie cutting with it. Found every time I would turn the saw and have the flywheel side up it would speed up at  idle and want to quit on transition. So I figured flywheel side seal. Replaced seal on the flywheel side today and decided to do a pressure and vac test. Holds vac well. Just leaks on pressure. One leak was on the manifold easy fix just tighten the clamp. The other leak is a bit more involved the case gasket is leaking on the intake side up the cylinder flange. So I will have to tear it down again. I did try to tighten the case bolt some more but the leak is still there. I did not figure it would fix it as I torqued the case bolts when I put the case halves together plus they are new old stock cases.