Author Topic: Echo cs301, 346, 306 saws  (Read 376 times)

0 Members and 85 Guests are viewing this topic.

Offline leec

  • 6 cube
  • ****
  • Posts: 264
  • Karma: 14
  • Location: Huntsville, Ontario

  • Total Badges: 23
    Badges: (View All)
    Sixth year Anniversary Fifth year Anniversary Level 5 Fourth year Anniversary Third year Anniversary 100 Posts
Echo cs301, 346, 306 saws
« on: January 13, 2017, 08:49:00 pm »
Couls I get an initial H & L carb setting for these saws.  manual only refers to carbs with limiters no inintial settings, ie 1 1/2 out for L and 1 out for high.  I know some of the newer saws are a lot further out.  Thanks

Share on Facebook Share on Twitter


Offline leec

  • 6 cube
  • ****
  • Posts: 264
  • Karma: 14
  • Location: Huntsville, Ontario

  • Total Badges: 23
    Badges: (View All)
    Sixth year Anniversary Fifth year Anniversary Level 5 Fourth year Anniversary Third year Anniversary 100 Posts
Re: Echo cs301, 346, 306 saws
« Reply #1 on: January 16, 2017, 09:52:03 pm »
OK guys I discouvered it myself, about 1 3/4 on L and 1 on H.  I'll run it a bit rich as it has a new piston with caber ring.

 

Related Topics

  Subject / Started by Replies Last post
3 Replies
750 Views
Last post September 26, 2011, 09:53:17 pm
by Cut4fun .
26 Replies
2572 Views
Last post September 13, 2012, 11:12:37 am
by SawTroll
8 Replies
961 Views
Last post September 28, 2013, 03:47:02 pm
by Cut4fun .
5 Replies
745 Views
Last post January 27, 2016, 09:04:28 pm
by 3000 FPS
3 Replies
1175 Views
Last post July 13, 2015, 12:44:12 am
by Eccentric
23 Replies
4430 Views
Last post December 18, 2014, 01:38:25 pm
by Cut4fun .
22 Replies
3782 Views
Last post September 04, 2016, 09:28:57 pm
by hseII
8 Replies
640 Views
Last post May 21, 2015, 12:44:22 pm
by Nathaniel Vansickle
0 Replies
461 Views
Last post October 17, 2019, 10:46:17 am
by Cut4fun .
1 Replies
427 Views
Last post February 17, 2024, 09:25:56 am
by old 040