Author Topic: UT10734R won't idle  (Read 115 times)

0 Members and 0 Guests are viewing this topic.

Offline James Vassil

  • pruner
  • *
  • Posts: 1
  • Karma: 0
UT10734R won't idle
« on: August 17, 2016, 04:21:39 pm »
UT10734R (14")

This saw was unused for several years. I filled it with a fresh mix of 32/1 (that was marked on the saw by a sharpie), cleaned and re-gapped the plug. I also put a new chain on it. It starts and runs and cuts fine but I have to keep the throttle up or it dies. I've adjusted the idle screw with no results. There are 2 other adjustment screws and I have not touched them. Someone told me they were probably the lo and hi adjustments. I don't have a shop manual so I don't know the reference points to adjust them.

Thanks in advance for any help on this and hagd.

Jim

Social Buttons


Offline Cut4fun .

  • Administrator
  • Nitro Hotsaw
  • *******
  • Posts: 17959
  • Karma: 338
  • OHIO REDNECK Saw Repair Getter Done
    • Redneck Chainsaw Repair
Re: UT10734R won't idle
« Reply #1 on: August 17, 2016, 07:27:27 pm »
 UT-10734-R CS3314  IPL https://www.partstree.com/parts/homelite/saws-chainsaw/cs3314-ut-10734-r-homelite-chainsaw/

L closest to engine, H furthest away.

Try opening your L up counterclockwise. If that dont help it may be your carb diaphragms have gotten stiff.
REDNECK Saw Repair Getter Done

 

Related Topics

  Subject / Started by Replies Last post
3 Replies
460 Views
Last post March 09, 2011, 07:47:49 pm
by hamish
47 Replies
2176 Views
Last post December 20, 2011, 06:28:27 pm
by mdavlee .
7 Replies
1485 Views
Last post April 20, 2012, 07:22:04 am
by farmboy
4 Replies
929 Views
Last post February 20, 2013, 01:47:20 pm
by Cut4fun .
3 Replies
398 Views
Last post February 15, 2013, 04:24:17 pm
by Cut4fun .
6 Replies
104 Views
Last post November 15, 2013, 08:19:21 pm
by Cut4fun
5 Replies
263 Views
Last post December 06, 2013, 07:42:56 pm
by Al Smith
7 Replies
103 Views
Last post March 03, 2014, 07:57:30 pm
by maxmag
5 Replies
319 Views
Last post June 21, 2015, 12:59:48 pm
by Cut4fun .
12 Replies
159 Views
Last post October 14, 2016, 07:03:38 pm
by dannyupsolate