Chainsaw Repair

Couldn't stand it had to do some work on this saw;
Got the side chain adjust installed
Piston is installed, using Caber rings and new Husqvarna clips
Measured squish with no base gasket 0.0215 on one side 0.0225 the other mean 0.022 so 1194 and no base gasket will send the solder from the squish measurement with saw
Cleaned up exhaust port
New pulse line and fuel line and filter installed

Should be back together for pressure test tomorrow! However pressure test has to wait 24 hours until the 1194 cures.

Not bad on the squish it should have some decent compression.

Thanks Roger, I try to build the best saws I am able!

A couple more, removed carb limiters, used yamabond4, changed starter sticker to 375XP, this is a factory sticker. All ready to rip!

Thanks Roger, we will see what the owner thinks after he runs it.

Looks real good Tim.   That saw should run like a champ.

LOL, like I'm going to complain, from something locked up to what you delivered....  I won't have the chance to try it out for a couple of weeks, but looking forward to it...

You have every right to complain, YOU are the customer who sent his saw off to an unknown guy for rebuild!