Author Topic: Jonsered 111 Dolmar 166 piston specs  (Read 1505 times)

0 Members and 52 Guests are viewing this topic.

Offline

  • Administrator
  • Nitro Hotsaw
  • *******
  • Posts: 24888
  • Karma: 665
  • OHIO REDNECK Saw Repair Getter Done
    • Redneck Chainsaw Repair

  • Total Badges: 53
    Badges: (View All)
    Tenth year Anniversary Nineth year Anniversary Level 8 Apple User Eighth year Anniversary 20000 Posts
Jonsered 111 Dolmar 166 piston specs
« on: December 06, 2017, 12:33:55 pm »
Here are some piston dimensions. 166 versus 111S from LeeH

Diameter 166 55.88 111S 55.89
Pin Diameter both 14mm
total height 166 49.50 111S 50.08
top of pin bore
to crown 166 17.50 111S 16.62 not counting crown
The 166 is a flat top, 111S is a domed piston
Put the pin through both pistons and the 166 is close to the top off
the 111S piston but the edge of the 166 is taller than the 111S so
it would make more compression providing there is room in the squish
band on the cylinder or have it machined.
I would say the 166 piston in a 111S would make more power.

Share on Bluesky Share on Facebook


Offline

  • Global Moderator
  • Nitro Hotsaw
  • *******
  • Posts: 1968
  • Karma: 171

  • Total Badges: 31
    Badges: (View All)
    Level 6 Sixth year Anniversary Fifth year Anniversary 1000 Posts Fourth year Anniversary 500 Posts
Re: Jonsered 111 Dolmar 166 piston specs
« Reply #1 on: December 07, 2017, 09:51:30 am »
Interesting. 166 with squish set in 111 would be best.

 

Related Topics

  Subject / Started by Replies Last post
72 Replies
15700 Views
Last post August 30, 2015, 01:21:23 pm
by Cut4fun .
2 Replies
3028 Views
Last post December 10, 2011, 10:38:37 pm
by 660magnum
0 Replies
878 Views
Last post October 25, 2011, 06:14:43 pm
by mdavlee
17 Replies
9627 Views
Last post August 26, 2015, 03:10:42 pm
by Cut4fun .
2 Replies
2130 Views
Last post June 19, 2014, 03:32:20 pm
by farmboy
6 Replies
1735 Views
Last post June 14, 2014, 02:48:05 pm
by KilliansRedLeo
16 Replies
3390 Views
Last post June 22, 2014, 10:11:57 pm
by aclarke
3 Replies
1383 Views
Last post October 18, 2014, 10:06:51 pm
by Al Smith
12 Replies
2566 Views
Last post January 24, 2016, 09:46:36 am
by Cut4fun .
1 Replies
2348 Views
Last post June 17, 2016, 04:52:19 pm
by 1manband